Experimental investigation of performance, emission and combustion characteristics of a CI engine fuelled by blends of waste plastic oil with diesel
- 26 August 2022
- journal article
- research article
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 44 (3) , 7693-7708
Abstract
In today’s society, waste plastic recycling has gained a lot of traction. The utility of energy has increased as a result of the significant increase in population expansion. Traditional fuels, such as petroleum and its byproducts, are finite resources that are insufficient to address fuel scarcity. In this scenario, an endless, low-cost, and readily available alternative fuel is required. The most acceptable solution is to extract fuel oil from waste plastics. Modification of waste plastics to productive fuel oil in a pyrolysis reactor is out through in this experimental investigation. The physio-chemical properties of plastic oil obtained in a pyrolysis reactor are compared to ASTM standards at the matching interval. The viscosity has increased, and carbon residue can be seen. At the pyrolysis reactor, diesel (80%) with waste plastic oil (20%) and diesel (60%) with waste plastic oil (40%) are combined in a volume ratio of 80% to 20%. Combustion analysis is performed in the diesel engine’s ignition chamber. The results indicated that employing waste plastics oil-diesel fuels in a diesel engine moderated thermal efficiency by 2.2% when associated to using pure diesel fuel at CR17.5. Furthermore, the peak rate of pressure rise, peak cylinder pressure, and smoke emission were all dime stored by 0.72%, 8.1%, and 1.5%, respectively. In analogy with diesel, waste plastic oil has slightly higher values. Even so there is additionally specific fuel consumption. The physic-chemical properties of waste plastic oil have superior influence on combustion besides performance characteristics.Keywords
Funding Information
- funding
This publication has 43 references indexed in Scilit:
- Experimental study on combustion and performance characteristics in a DI CI engine fuelled with blends of waste plastic oilAlexandria Engineering Journal, 2018
- Impact of waste cooking oil in biodiesel blends on particle size distributions from a city-car engineJournal of the Energy Institute, 2018
- An experimental study of combustion, performance, exergy and emission characteristics of a CI engine fueled by Diesel-ethanol-biodiesel blendsEnergy, 2017
- Alternative Diesel from Waste PlasticsEnergies, 2017
- Impact of oxygenated cottonseed biodiesel on combustion, performance and emission parameters in a direct injection CI engineInternational Journal of Ambient Energy, 2017
- Effect of plastic waste types on pyrolysis liquid oilInternational Biodeterioration & Biodegradation, 2017
- Combustion and emission characteristics of diesel-tung oil-ethanol blended fuels used in a CRDI diesel engine with different injection strategiesApplied Thermal Engineering, 2017
- Time and temperature depended fuel gas generation from pyrolysis of real world municipal plastic wasteFuel, 2016
- Fuel Oil Production from Municipal Plastic Wastes in Sequential Pyrolysis and Catalytic Reforming ReactorsEnergy Procedia, 2014
- Experimental investigation of performance, emission and combustion characteristics of an indirect injection multi-cylinder CI engine fuelled by blends of de-inking sludge pyrolysis oil with biodieselFuel, 2013