Mechanical and Thermal Properties of Poly(L‐lactide) Incorporating Various Inorganic Fillers with Particle and Whisker Shapes
- 30 June 2003
- journal article
- research article
- Published by Wiley in Macromolecular Materials and Engineering
- Vol. 288 (7) , 562-568
Abstract
Poly(L‐lactide) (PLLA) composites incorporating various inorganic fillers (ifR‐PLA) were prepared by the melt blending technique, and their mechanical and thermal properties were evaluated. The filler types influenced the mechanical properties of ifR‐PLA; for those incorporating particle‐ and whisker‐type fillers the tensile moduli were 3.1–3.7 and 3.7–4.5 GPa, respectively, and the flexural moduli were 4.1–4.8 and 4.8–6.1 GPa. It was found that the tensile strength and modulus, as well as the flexural modulus, of ifR‐PLA incorporating whisker‐type fillers increased in proportion to the volume percent of the fillers (Vf). The flexural strength of ifR‐PLA incorporating 9Al2O3 · 2B2O3 whiskers showed a similar increase, while that of ifR‐PLA incorporating CaCO3 whiskers showed a decrease with increasing Vf. This difference may be because the 9Al2O3 · 2B2O3 with its large aspect ratio kept its original fibrous shape, while the CaCO3 lost its fibrous shape during the blending process. However, the reinforcing effect of these fillers was relatively low compared with that known for the corresponding composites of the conventional polymeric materials, probably because of the poor surface adhesion of PLLA to the fillers. Comparison of effect on storage moduli of different fillers. magnified image Comparison of effect on storage moduli of different fillers.Keywords
This publication has 16 references indexed in Scilit:
- Properties and Biodegradability of Polymer Blends of Poly(L-lactide)s with Different Optical Purity of the Lactate UnitsMacromolecular Materials and Engineering, 2002
- Immiscible polymer blends of semicrystalline biocompatible components: thermal properties and phase morphology analysis of PLLA/PCL blendsPolymer, 2001
- In vitrodegradation behavior of carbon fiber‐reinforced PLA composites and influence of interfacial adhesion strengthJournal of Applied Polymer Science, 2001
- Polylactide stereocomplex crystallites as nucleating agents for isotactic polylactideJournal of Polymer Science Part B: Polymer Physics, 2000
- Structure and thermal/mechanical properties of poly(l-lactide)-clay blendJournal of Polymer Science Part B: Polymer Physics, 1997
- Flexural Properties of Unidirectional Composites Laminarily Reinforced with Mesophase Pitch Based Carbon Fibers and Alumina Fibers.Sen'i Gakkaishi, 1996
- Properties and morphologies of poly(?-lactide): 1. Annealing condition effects on properties and morphologies of poly(?-lactide)Polymer, 1995
- Absorbable self-reinforced polylactide (SR-PLA) composite rods for fracture fixation: strength and strength retention in the bone and subcutaneous tissue of rabbitsJournal of Materials Science: Materials in Medicine, 1992
- Resorbable materials of poly(L‐lactide). II. Fibers spun from solutions of poly(L‐lactide) in good solventsJournal of Applied Polymer Science, 1983
- Biodegradable poly(lactic acid) polymersJournal of Biomedical Materials Research, 1971