Analytical determination of the surface energy of sub-5nm head-disk interfaces accounting for multilayer effects
- 15 April 2006
- journal article
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 99 (8) , 08N111
Abstract
In this work, a five-layer HDI configuration was employed to derive a simple way to relate the multilayer Hamaker constant to an effective surface energy of the HDI. Specifically, the five layers of the HDI include two layers on the slider [diamondlike carbon (DLC) overcoat, Al2O3–TiC] and two layers on the disk (lubricant, DLC overcoat) as well as the air gap (or flying height). Following the formulation for two equivalent homogeneous surfaces, one can derive the effective surface energy of the five-layer model. To investigate the effect of the topmost layer thicknesses of the slider and disk on the surface energy, they were first varied from 2 to 5nm and from 0.5 to 2nm, respectively. It was found that the surface energy depends largely on the disk lubricant thickness while it has little dependence on the slider DLC thickness. Lubricant pickup by the slider and its effect on the surface energy was also investigated and it was found that the overall surface energy of the interface is lower when there is lubricant pickup.Keywords
This publication has 9 references indexed in Scilit:
- Experimental and Numerical Investigation of Dynamic Instability in the Head Disk Interface at ProximityJournal of Tribology, 2005
- Adhesive contact based on the Lennard–Jones potential: a correction to the value of the equilibrium distance as used in the potentialJournal of Colloid and Interface Science, 2004
- The interactions between Z-Tetraol perfluoropolyether lubricant and amorphous nitrogenated- and hydrogenated-carbon surfaces and silicon nitrideJournal of Fluorine Chemistry, 2004
- Design Consideration of Contact/Near-Contact Sliders Based on a Rough Surface Contact ModelJournal of Tribology, 2003
- Possibility of surface force effect in slider air bearings of 100 Gbit/in2 hard disksTribology International, 2003
- Comparison of the corrosion behavior of die-upset and sintered NdFeB magnetsIEEE Transactions on Magnetics, 2001
- De-wetting of lubricants on hard disksThe Journal of Chemical Physics, 2000
- Concerning the Interactions between Zdol Perfluoropolyether Lubricant and an Amorphous-Nitrogenated Carbon SurfaceLangmuir, 1998
- On two methods of calculation of the force of sticking of an elastic sphere to a rigid planeColloids and Surfaces, 1983