Smart Water Meter Using Electrical Resistance Tomography
Open Access
Abstract
Smart flow monitoring is critical for sewer system management. Obstructions and restrictions to flow in discharge pipes are common and costly. We propose the use of electrical resistance tomography modality for the task of smart wastewater metering. This paper presents the electronics hardware design and bespoke signal processing to create an embedded sensor for measuring flow rates and flow properties, such as constituent materials in sewage or grey water discharge pipes of diameters larger than 250 mm. The dedicated analogue signal conditioning module, zero-cross switching scheme, and real-time operating system enable the system to perform low-cost serial measurements while still providing the capability of real-time capturing. The system performance was evaluated via both stationary and dynamic experiments. A data acquisition speed of 14 frames per second (fps) was achieved with an overall signal to noise ratio of at least 59.54 dB. The smallest sample size reported was 0.04% of the domain size in stationary tests, illustrating good resolution. Movements have been successfully captured in dynamic tests, with a clear definition being achieved of objects in each reconstructed image, as well as a fine overall visualization of movement.Keywords
This publication has 22 references indexed in Scilit:
- Rapid detection of sewer defects and blockages using acoustic-based instrumentationWater Science & Technology, 2011
- A novel tomographic sensing system for high electrically conductive multiphase flow measurementFlow Measurement and Instrumentation, 2010
- GREIT: a unified approach to 2D linear EIT reconstruction of lung imagesPhysiological Measurement, 2009
- Understanding blockage formation in combined sewer networksProceedings of the Institution of Civil Engineers - Water Management, 2008
- Identification of gas/liquid two-phase flow regime through ERT-based measurement and feature extractionFlow Measurement and Instrumentation, 2007
- Two Methods for Measurement of Gas-Liquid Flows in Vertical Upward Pipe Using Dual-Plane ERT SystemIEEE Transactions on Instrumentation and Measurement, 2006
- Plug flow of yoghurt in piping as determined by cross-correlated dual-plane electrical resistance tomographyJournal of Food Engineering, 2006
- Electrical resistance tomography using a bi-directional current pulse techniqueMeasurement Science and Technology, 2001
- Measurement of angular velocities using electrical impedance tomographyFlow Measurement and Instrumentation, 1998
- Electrical resistance tomography for process applicationsMeasurement Science and Technology, 1996