On the Chip Shaping and Surface Topography When Finish Cutting 17-4 PH Precipitation-Hardening Stainless Steel under Near-Dry Cutting Conditions
Open Access
Abstract
This study describes the surface topography of the 17-4 PH stainless steel machined under dry, wet and near-dry cutting conditions. Cutting speeds of 150–500 m/min, feeds of 0.05–0.4 mm/rev and 0.5 mm depth of cutting were applied. The research was based on the ‘parameter space investigation’ method. Surface roughness parameters, contour maps and material participation curves were analysed using the optical Sensofar S Neox 3D profilometer and the effect of feed, cutting speed and their mutual interaction was noticed. Changes in chip shape depending on the processing conditions are shown. Compared to dry machining, a reduction of Sa, Sq and Sz parameters of 38–48% was achieved for near-dry condition. For lower feeds and average cutting speeds valleys and ridges were observed on the surface machined under dry, wet and near-dry conditions. For higher feeds and middle and higher cutting speeds, deep valleys and high ridges were observed on the surface. Depending on the processing conditions, different textures of the machined surface were registered, particularly anisotropic mixed, periodic and periodically determined. In the Sa range of 0.4–0.8 μm for dry and wet conditions the surface isotropy is ~20%, under near-dry conditions it is ~60%.Keywords
Funding Information
- Polish Minister of Science and Higher Education (003/RID/2018/19)
This publication has 32 references indexed in Scilit:
- Tool damage and machined-surface quality using hot-pressed sintering Ti(C7N3)/WC/TaC cermet cutting inserts for high-speed turning stainless steelsThe International Journal of Advanced Manufacturing Technology, 2015
- Use of Castor Oil as Cutting Fluid in Machining of Hardened Stainless Steel with Minimum Quantity of LubricantProcedia CIRP, 2015
- Cryogenic Machining-Induced Surface Integrity: A Review and Comparison with Dry, MQL, and Flood-Cooled MachiningMachining Science and Technology, 2014
- Tribological behaviour of antiwear additives used in hydraulic applications: Synergistic or antagonistic with other surface-active additives?Tribology International, 2013
- Characterization of 17-4 PH stainless steel foam for biomedical applications in simulated body fluid and artificial saliva environmentsMaterials Science and Engineering: C, 2013
- Wavelet Transform Feature Extraction for Chip form Recognition during Carbon Steel TurningProcedia CIRP, 2013
- Machining of AISI 316 Stainless Steel under Carbon-Di-Oxide CoolingMaterials and Manufacturing Processes, 2012
- An experimental investigation on contact length during minimum quantity lubrication (MQL) machiningJournal of Materials Processing Technology, 2008
- Enhancement of Wet- and MQL-Based Machining of Automotive Alloys Using Cutting Tools with DLC/Polymer Surface TreatmentsJournal of Materials Engineering and Performance, 2008
- Activated gas nitriding of 17-4 PH stainless steelSurface and Coatings Technology, 2006