EDM of Ti-6Al-4V under Nano-Graphene Mixed Dielectric: A Detailed Investigation on Axial and Radial Dimensional Overcuts
Open Access
- 27 January 2022
- journal article
- research article
- Published by MDPI AG in Nanomaterials
- Vol. 12 (3) , 432
Abstract
Ti-6Al-4V is considered a challenging material in terms of accurate machining. Therefore, electric discharge machining (EDM) is commonly engaged, but its low cutting rate depreciates its use. This issue is resolved if graphene nanoparticles are mixed in the dielectric. However, the control over the sparking phenomenon reduces because of the dispersion of graphene particles. Subsequently, the machined profile’s geometric accuracy is compromised. Furthermore, the presence of nanographene induces different sparks along axial and radial cutting orientations. This aspect has not been comprehensively examined yet and dedicatedly targeted in this study to improve the quality of EDM process for Ti-6Al-4V. A total of 18 experiments were conducted under Taguchi’s L18 design considering six parameters namely, electrode type, polarity, flushing time, spark voltage, pulse time ratio, and discharge current. The aluminum electrode proved to be the best choice to reduce the errors in both the cutting orientations. Despite the other parametric settings, negative tool polarity yields lower values of axial (ADE) and radial errors (RDE). The developed optimal settings ensure 4.4- and 6.3-times reduction in RDE and ADE, respectively. In comparison to kerosene, graphene-based dielectric yields 10.2% and 19.4% reduction in RDE and ADE, respectively.Keywords
This publication has 53 references indexed in Scilit:
- Experimental study and analysis of micro holes machining in EDM of SS 304International Journal of Machining and Machinability of Materials, 2013
- Mathematical modeling of electric discharge machining of cast Al–4Cu–6Si alloy–10wt.% SiCP compositesJournal of Materials Processing Technology, 2007
- A review on current research trends in electrical discharge machining (EDM)International Journal of Machine Tools and Manufacture, 2007
- Technology and research developments in powder mixed electric discharge machining (PMEDM)Journal of Materials Processing Technology, 2007
- The effect in EDM of a dielectric of a urea solution in water on modifying the surface of titaniumInternational Journal of Machine Tools and Manufacture, 2005
- An overview of the machinability of aeroengine alloysJournal of Materials Processing Technology, 2003
- Dimensional accuracy optimisation of multi-stage planetary EDMInternational Journal of Machine Tools and Manufacture, 2002
- Semi-empirical model of surface finish on electrical discharge machiningInternational Journal of Machine Tools and Manufacture, 2001
- Micro-hole machining of carbide by electric discharge machiningJournal of Materials Processing Technology, 1999
- Titanium alloys and their machinability—a reviewJournal of Materials Processing Technology, 1997