NDE of Concrete Strength and Elasticity Modulus Based on Jerk Measurement
Open Access
- 28 January 2024
- journal article
- research article
- Published by Springer Nature in Journal of Nondestructive Evaluation
- Vol. 43 (1) , 1-18
Abstract
The quality assessment of concrete material for new or existing buildings is critical to civil and structural engineers. In this scope, the development of nondestructive testing methods (NDT) has received significant attention and becomes essential for enhancing the on-site assessment of concrete performance. The Schmidt hammer (SH) test is one of the most widely used NDT for quantifying concrete strength. However, the reliability of this test and its accuracy are questioned by many researchers. In this study, the measurement quality of SH has been improved by attaching a developed cantilever-based jerk sensor to the SH mass. The theoretical model of the proposed measurement technique has been formulated and discussed. The experimental approach, jerk sensor design, SH body modification, electronic reading unit, testing, and construction of the calibration curves have been presented. Experimental results revealed that the accuracy of the developed SH has increased by 13% for concrete strength measurement, and the correlation coefficient of the strength calibration curve is 0.94. At the same time, the calibration curve of the concrete elasticity modulus showed a 0.93 correlation coefficient with 92% measurement accuracy. Analytical and experimental results have confirmed the applicability of the modified Schmidt hammer since it is reliable and more accurate compared to the traditional Schmidt Hammer.Keywords
Funding Information
- Ministry of Higher Education
- Egypt Japan University
This publication has 15 references indexed in Scilit:
- Characteristic Curve and Its Use in Determining the Compressive Strength of Concrete by the Rebound Hammer TestMaterials, 2019
- Testing of concrete by rebound method: Leeb versus Schmidt hammersMaterials and Structures, 2018
- Influence of Selected Factors on the Relationship between the Dynamic Elastic Modulus and Compressive Strength of ConcreteMaterials, 2018
- Repeatability of the rebound surface hardness of concrete with alteration of concrete parametersConstruction and Building Materials, 2017
- Application of ultrasonic surface wave techniques for concrete bridge deck condition assessmentJournal of Applied Geophysics, 2016
- The Influence of Concrete Composition on Young's ModulusProcedia Engineering, 2015
- Reliability of core test – Critical assessment and proposed new approachAlexandria Engineering Journal, 2014
- Rebound surface hardness of concrete: Introduction of an empirical constitutive modelConstruction and Building Materials, 2011
- Generalized Morse waveletsIEEE Transactions on Signal Processing, 2002
- Dynamic hardness testing of metallic materialsNDT International, 1979