Analysis of temperature distribution over pipe surfaces of air-based cavity linear receiver for cross-linear concentration solar power system
- 18 November 2022
- journal article
- research article
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 30 (11) , 28621-28639
Abstract
This analysis is based on the computational fluid dynamics (CFD) of the air-based solar cavity linear receiver (CLR) of the cross-linear concentrated solar power plant. In this study, the temperature distribution along the pipe surface is investigated using a small section of a receiver. To study the variation of temperature over the surface of receiver pipes, a CFD model has been developed in Ansys Fluent. The analysis shows the effect of reflected radiation on the temperature variation over the front and back surfaces of the pipes, as well as the effect of this variation on heat transfer fluid (HTF) outlet temperature. The difference in the HTF outlet temperature and heat transfer rate between experimental data and CFD results has been identified. After rigorous examination, it has been observed that the effective range of length for heat absorbing pipe is from 60 to 600 mm (outlet) as HTF continues to absorb heat in this range. The average heat transfer rate was observed to be around 14108 W. Finally, the effect of variable mass flow rate over thermal efficiency of the receiver has been examined and it has been observed that once the mass flow rate exceeds 0.06 kg/s, further increasing the mass flow rate has little effect on improving the thermal efficiency because after an optimum value of mass flow rate would result in increase in heat loss from the pipe’s back wall. In the present study, the results of the CFD analysis have been validated with an experimental test data.Keywords
This publication has 28 references indexed in Scilit:
- Numerical analysis of convective and radiative heat losses from trapezoidal cavity receiver in LFR systemsSolar Energy, 2016
- Computational fluid dynamics evaluation of the operating conditions for a volumetric receiver installed in a solar towerEnergy, 2016
- Optimization of a trapezoidal cavity absorber for the Linear Fresnel ReflectorSolar Energy, 2015
- Thermal design guidelines of solar power towersApplied Thermal Engineering, 2014
- Cross Linear Solar Concentration System for CSP and CPVEnergy Procedia, 2014
- Packed-bed thermal storage for concentrated solar power – Pilot-scale demonstration and industrial-scale designSolar Energy, 2012
- Corrosion behavior of alloy 800H (Fe–21Cr–32Ni) in supercritical waterCorrosion Science, 2011
- Modeling of a hazelnut dryer assisted heat pump by using artificial neural networksApplied Energy, 2008
- Application of a Reynolds stress turbulence model to the compressible shear layerAIAA Journal, 1991
- The numerical computation of turbulent flowsComputer Methods in Applied Mechanics and Engineering, 1974