Dosimetric characteristics of LiF:Mg,Cu,Si thermoluminescent materials
Authors:
- 28 August 2006
- journal article
- conference paper
- Published by AIP Publishing in Applied Physics Letters
- Vol. 89 (9) , 094110
Abstract
Dosimetric characteristics of LiF:Mg,Cu,Si thermoluminescent (TL) material developed at KAERI have been investigated and compared with those of commercially available LiF:Mg,Cu,P (GR-200A). LiF:Mg,Cu,Si thermoluminescence dosimeter (TLD) can be heated up to without any loss of TL sensitivity or any change in the glow curve structure. High-temperature glow peak in LiF:Mg,Cu,Si is significantly lower than that in GR-200A, consequently the residual signal is only 0.025%, which is about 35 times less than that of GR-200A. The TL sensitivity of the LiF:Mg,Cu,Si TLD is about 55 and 1.1 times higher than those of the LiF:Mg,Ti (TLD-100) and GR-200A, respectively.
Keywords
This publication has 7 references indexed in Scilit:
- Developments in the synthesis of LiF:Mg,Cu,Na,Si TL MaterialRadiation Protection Dosimetry, 2004
- A New Paradigm in Personal Dosimetry Using LiF:Mg,Cu,PRadiation Protection Dosimetry, 2002
- A New High Sensitivity Thermoluminescent Phosphor with Low Residual Signal and Good Stability to Heat Treatment: LiF:Mg,Cu,Na,SiRadiation Protection Dosimetry, 2002
- Preparation and Characteristics of LiF:Mg,Cu,P Thermoluminescent MaterialRadiation Protection Dosimetry, 1993
- Elimination of the Residual Signal in LiF:Cu,Mg,PRadiation Protection Dosimetry, 1992
- Measurements of emission spectra during thermoluminescence (TL) from LiF(Mg, Cu, P) TL dosimetersJournal of Physics D: Applied Physics, 1991
- Development of a new highly sensitive LiF thermoluminescence dosimeter and its applicationsNuclear Instruments and Methods, 1978