A Simple and Cost‐Effective Approach to Fabrication of Dense Ceramic Membranes on Porous Substrates
- 1 August 2001
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 84 (8) , 1903-1905
Abstract
A simple and elegant approach to fabrication of dense ceramic membranes on porous substrates, a traditional dry pressing of foam powders, has been developed to reduce the cost of fabrication. Gd‐doped ceria (GDC, Gd 0.1 Ce 0.9 O 1.95 ) electrolyte membranes as thin as 8 μm are obtained by dry‐pressing highly porous GDC powders. The membrane thickness can be readily controlled by the amount of powder. The electrolyte membranes are studied in a solid‐oxide fuel cell (SOFC) with air as oxidant and humidified hydrogen (3% H 2 O) as fuel. Open‐circuit voltages of about 1.0 V are observed, implying that the permeability of the membranes to molecular gases is insignificant. Power densities of 140 and 380 mW/cm 2 are demonstrated at 500° and 600°C, respectively, representing a significant progress in developing low‐temperature SOFCs.Keywords
This publication has 6 references indexed in Scilit:
- Reduced-Temperature Solid Oxide Fuel Cells Fabricated by Screen PrintingElectrochemical and Solid-State Letters, 2001
- Advances in solid oxide fuel cell technologySolid State Ionics, 2000
- Fabrication of thin electrolytes for second-generation solid oxide fuel cellsSolid State Ionics, 2000
- Appraisal of Ce1−yGdyO2−y/2 electrolytes for IT-SOFC operation at 500°CSolid State Ionics, 2000
- Development of Solid‐Oxide Fuel Cells That Operate at 500°CJournal of the Electrochemical Society, 1999
- Characterisation of (CeO2)0.8(GdO1.5)0.2 synthesised using various techniquesSolid State Ionics, 1998