Effect of substrates temperature on structural and optical properties indium tin oxide prepared by RF magnetron sputtering
- 1 December 2016
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
Abstract
This project has been focused on the structural and optical properties respectively on the effect of indium tin oxide (ITO) thin films at different substrates temperature. The substrates temperature is varied at room temperature, 100°C, 200°C, 300°C and 400 °C as the parameter to optimize the thin films quality. ITO thin films were deposited onto the glass substrates using RF magnetron sputtering ITO (In-Sn, 90-10%) targets. This project was involved with three phases, which are thin films preparation, deposition and characterization. The thin films were characterized using field emission scanning electron microscopy (FESEM), atomic force microscopy (AFM) and ultraviolet-visible-near-infrared (UV-Vis-NIR) spectrophotometer (Perkin Elmer Lambda 750) for structural properties and optical properties. The absorption coefficient spectrum obtained shows all films exhibit very low absorption in the visible (400-800nm) and near infrared (NIR) (>800nm) range but exhibit high absorption in the UV range. The samples show higher transmittance of more than 80% at 350 nm.Keywords
This publication has 25 references indexed in Scilit:
- Surface studies and photoluminescence of GaN epitaxial layers grown by MOCVD technique for applications of solar cells and light emitting devicesJournal of Alloys and Compounds, 2016
- Highly sensitive formaldehyde resistive sensor based on a single Er-doped SnO2 nanobeltPhysica B: Condensed Matter, 2016
- Structure, optical and electrical properties of indium tin oxide ultra thin films prepared by jet nebulizer spray pyrolysis techniqueJournal of Asian Ceramic Societies, 2016
- Surface nano/micro functionalization of PMMA thin films by 157nm irradiation for sensing applicationsApplied Surface Science, 2008
- Structural characterization of nickel–titanium film on silicon carbideApplied Surface Science, 2008
- Effects of microwave plasma treatment on the field emission properties of printed carbon nanotubes/Ag nano-particles filmsApplied Surface Science, 2007
- Pulsed Laser Deposition of epitaxial SrTiO3 films: Growth,structure and functional propertiesThin Solid Films, 2007
- Nanostructured tungsten oxide with controlled properties: Synthesis and Raman characterizationThin Solid Films, 2007
- Sol–gel preparation of poly(ethylene glycol) doped indium tin oxide thin films for sensing applicationsOptical Materials, 2004
- Room-temperature deposition of indium tin oxide thin films with plasma ion-assisted evaporationThin Solid Films, 1998