Distinct Difference in Ionic Transport Behavior in Polymer Electrolytes Depending on the Matrix Polymers and Incorporated Salts
Authors:
- 12 February 2005
- journal article
- research article
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry B
- Vol. 109 (9) , 3886-3892
Abstract
Two different electrolyte salts, lithium bis(trifluoromethanesulfonyl)imide (LiTFSI), and a room temperature ionic liquid, 1-ethyl-3-methylimidazolium bis(trifluoromethanesulfonyl)imide (EMITFSI), were incorporated into network polymers to obtain ion-conductive polymer electrolytes. Network polymers of poly(ethylene oxide-co-propylene oxide) (P(EO/PO)) and poly(methyl methacrylate) (PMMA) were chosen as matrixes for LiTFSI and EMITFSI, respectively. Both of the polymer electrolytes were single-phase materials and were completely amorphous. Ionic conductivity of the polymer electrolytes was measured over a wide temperature range, with the lowest temperatures close to or below the glass transition temperatures (Tg). The Arrhenius plots of the conductivity for both of the systems exhibited positively curved profiles and could be well fit to the Vogel−Tamman−Fulcher (VTF) equation. The conductivity of the PMMA/EMITFSI electrolytes was higher at most by 3 orders of magnitude than that of the LiTFSI/P(EO/ PO) electrolytes at ambient temperature. When the ideal glass transition temperature, T0 (one of the VTF fitting parameters), was compared with the Tg, a difference in the ionic conduction was apparent in these systems. In the P(EO/PO)/LiTFSI electrolytes, the T0 and Tg increased in parallel with salt concentration and the T0 was lower than the Tg by ca. 50 °C. On the contrary, the difference between the T0 and the Tg increased with increasing content of PMMA in the PMMA/EMITFSI electrolytes, with the observed difference in the concentration range studied reaching up to ca. 100 °C. The conductivity at the Tg, σ(Tg), for the LiTFSI/P(EO/PO) electrolytes was on the order of 10-14-10-13 S cm-1 and increased with increasing salt concentration, whereas that for the PMMA/EMITFSI polymer electrolytes reached 10-7 S cm-1 when the concentration of PMMA was high. The ion transport mechanism was discussed in terms of the concepts of coupling/decoupling and strong/fragile for the two different polymer electrolytes.Keywords
This publication has 49 references indexed in Scilit:
- High performance dye-sensitized solar cells using ionic liquids as their electrolytesJournal of Photochemistry and Photobiology A: Chemistry, 2004
- Pulsed-Gradient Spin−Echo 1H and 19F NMR Ionic Diffusion Coefficient, Viscosity, and Ionic Conductivity of Non-Chloroaluminate Room-Temperature Ionic LiquidsThe Journal of Physical Chemistry B, 2001
- First principles modelling of amorphous polymer electrolytes: Li+–PEO, Li+–PEI, and Li+–PES complexesPolymer, 2001
- Highly conductive polymer electrolytes prepared by in situ polymerization of vinyl monomers in room temperature molten saltsElectrochimica Acta, 2000
- High ionic conductivity and electrode interface properties of polymer electrolytes based on high molecular weight branched polyetherJournal of Power Sources, 1999
- Modelling amorphous lithium salt–PEO polymer electrolytes: ab initio calculations of lithium ion–tetra-, penta- and hexaglyme complexesPolymer, 1999
- Ion Transport in Glassy Polymer ElectrolytesThe Journal of Physical Chemistry B, 1999
- CorrespondenceSolid State Ionics, 1998
- Hydrophobic, Highly Conductive Ambient-Temperature Molten SaltsInorganic Chemistry, 1996
- High ionic conductivity of new polymer electrolytes consisting of polypyridinium, pyridinium and aluminium chlorideJournal of the Chemical Society, Chemical Communications, 1993