Design, fabrication, and testing of an active camber rotor blade tip
- 11 December 2021
- journal article
- research article
- Published by SAGE Publications in Journal of Intelligent Material Systems and Structures
- Vol. 33 (13) , 1663-1677
Abstract
This paper presents a morphing blade design for wind turbine application with flexibility in chord-wise bending while providing sufficient stiffness to carry the aerodynamic loads. The NACA64 profile is selected for the camber morphing blade demonstrator. A corrugation concept is chosen because it is relatively easy to manufacture and provides sufficient stiffness to resist deformation due to the aerodynamic loads (through the provision of effective stringers) while providing the required flexibility for chord-wise bending. A mechanical actuation mechanism is employed to achieve the desired morphing angle and increase the stiffness of the morphing airfoil section to resist aerodynamic loading. The design of a morphing blade demonstrator is presented together with the manufacturing process. Finally, an experimental study is conducted where the morphing angle is measured for increasing actuation load and compared with FE analysis showing good agreement between the experimental results and results from the finite element analysis in addition to achieving the desired morphing angle.Keywords
Funding Information
- New York State Energy Research and Development Authority (58059)
This publication has 28 references indexed in Scilit:
- Optimization‐based study of bend–twist coupled rotor blades for passive and integrated passive/active load alleviationWind Energy, 2012
- A morphing trailing edge device for a wind turbineJournal of Intelligent Material Systems and Structures, 2012
- A Review of Morphing AircraftJournal of Intelligent Material Systems and Structures, 2011
- Review of state of the art in smart rotor control research for wind turbinesProgress in Aerospace Sciences, 2010
- Deformable trailing edge flaps for modern megawatt wind turbine controllers using strain gauge sensorsWind Energy, 2009
- Skin design studies for variable camber morphing airfoilsSmart Materials and Structures, 2008
- Design Optimization of a Controllable Camber Rotor AirfoilAIAA Journal, 2008
- Active load reduction using individual pitch, based on local blade flow measurementsWind Energy, 2004
- Individual Blade Pitch Control for Load ReductionWind Energy, 2002
- XFOIL: An Analysis and Design System for Low Reynolds Number Airfoils1989