Foam fractionation of colloid‐surfactant systems
Authors:
- 1 March 1965
- journal article
- research article
- Published by Wiley in AIChE Journal
- Vol. 11 (2) , 274-279
Abstract
The presence of colloidal particulates has a significant effect upon the foam fractionation of aqueous solutions of surface‐active agents. An experimental investigation is presented of the foam fractionation‐flotation of the stannic oxide‐cetyltrimethylammonium bromide (CTAB) and stannic oxide‐alkyl benzene sulfonate (ABS) systems. The average diameter of the stannic oxide particles was 180Å, and particle concentrations were determined by turbidmetry. For stannic oxide‐CTAB a froth flotation mechanism controls, and upon foaming feed sols of fixed concentration, fractional residuals of particulates and surfactant are approximately equal. Maximum enrichment ratios are obtained at maximum aeration time, minimum air rate, and maximum foam height. Increasing the feed concentration of particulates increases the collapsed foam volume, while the CTAB concentration in the residual sol first decreases and then becomes virtually constant. For stannic oxide‐ABS sols, no particulates are removed preferentially in the foam. A foam fractionation mechanism controls, and compared with ABS solutions the addition of stannic oxide decreases the foam volume and residual ABS concentration, producing a pronounced increase in the enrichment ratio.Keywords
This publication has 4 references indexed in Scilit:
- Effect of the Foam-Liquid Solution Interface On Continuous Foam SeparationNature, 1963
- The stability of hydrophobic sols in the presence of surface-active agents. Part 2.—The stability of silver iodide sols in the presence of cationic surface-active agentsTransactions of the Faraday Society, 1960
- Fundamental Properties of Textile Wastes. VIII. The Flotation of Colloidal Suspensions †Textile Research, 1938
- Fundamental Properties of Textile Wastes. V. Flotation from Ferric Oxide SolsTextile Research, 1938