Control systems for scanning tunneling microscopes with tube scanners
Authors:
- 1 June 1989
- journal article
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 60 (6) , 997-1002
Abstract
The design of the control system for a scanning tunneling microscope is described. The control system was optimized for a tube scanner instrument and for constant-current-mode operation. The optimization process included measurement of the transient and frequency responses of the instrument, design of the appropriate control electronics, and development of software consistent with the characteristics of the instrument and electronics. The limiting factor for tube scanner performance was found to be the transient settling time rather than the lowest mechanical resonant frequency of the tube. The settling time for the mechanical resonances of the tube scanner was reduced from 100 to 1 ms by potting the device with silicone rubber. After the potting procedure, the sensitivity of the tube scanner was essentially unchanged.Keywords
This publication has 8 references indexed in Scilit:
- Theories of the feedback and vibration isolation systems for the scanning tunneling microscopeReview of Scientific Instruments, 1987
- Scanning tunneling microscopeReview of Scientific Instruments, 1987
- Single-tube three-dimensional scanner for scanning tunneling microscopyReview of Scientific Instruments, 1986
- Some design criteria in scanning tunneling microscopyIBM Journal of Research and Development, 1986
- Imaging in real time with the tunneling microscopeApplied Physics Letters, 1986
- 7 × 7 Reconstruction on Si(111) Resolved in Real SpacePhysical Review Letters, 1983
- Surface Studies by Scanning Tunneling MicroscopyPhysical Review Letters, 1982
- Tunneling through a controllable vacuum gapApplied Physics Letters, 1982