Factors That Influence the Decay Rate of the Potential at the Surface of Nonwoven Fabrics After Negative Corona Discharge Deposition
- 10 May 2010
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industry Applications
- Vol. 46 (4) , 1586-1592
Abstract
Surface potential decay (SPD) measurements are considered as the most appropriate technique for the investigation of the corona charging of dielectric surfaces. The aim of the experiments reported in the present paper was to point out the peculiarities of SPD in the case of nonhomogeneous dielectrics, such as the nonwoven fabrics employed for heat, ventilation, and air conditioning. This paper reports experimental data collected on two types of polypropylene (PP) media, characterized by different fiber diameters. The experiments were performed on 60 mm × 50 mm samples of nonweaved sheets of PP (sheet thickness: 400 μm; average fiber diameter: 20 μm), in ambient air (temperature: 18°C to 22°C; relative humidity: 25% to 60%). The samples were charged for 10 s by exposing them to the negative corona discharge, using a triode-type electrode arrangement, energized from a dc high-voltage supply. Their surface potential was then measured with an electrostatic voltmeter. The measured data indicate that the charge of the filter is limited by the local discharges that occur inside the fibrous dielectric.Keywords
This publication has 20 references indexed in Scilit:
- Cavity detection on organic coatings by electrostatic measurements: A detailed study using FR4 fiberglass epoxy laminatesJournal of Electrostatics, 2008
- Charging characteristics of a nonwoven sheet air filter2003
- Surface potential measurements: Implementation and interpretation2000
- Charge injection in corona-charged polymeric films: potential decay and current measurementsJournal of Electrostatics, 1999
- Parameters Affecting the Loading Behavior and Degradation of Electrically Active Filter MaterialsAerosol Science and Technology, 1998
- Determination of the very low-frequency characteristics of dielectric materials: A surface potential approachJournal of Applied Physics, 1996
- Surface potential decay on corona-charged epoxy samples due to polarization processesJournal of Physics D: Applied Physics, 1995
- Surface charging limit for a woven fabric on a ground planeJournal of Electrostatics, 1995
- Kinetics of xerographic discharge by surface charge injectionJournal of Applied Physics, 1992
- Charge transport, charge injection and breakdown in polymeric insulatorsJournal of Physics D: Applied Physics, 1990