Microstructure, thermal, physico–mechanical and tribological characteristics of molybdenum disulphide‐filled polyamide 66/carbon black composites
Authors:
- 13 December 2012
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 53 (8) , 1676-1686
Abstract
With an objective to investigate the influence of molybdenum disulphide (MoS2) on physico–mechanical and tribological properties of polyamide 66 (PA 66), was compounded with MoS2 in the presence of carbon black (CB). The compounded material was injection molded to make test specimens to evaluate physico–mechanical, thermal, and tribological (wear, friction, and laser etching) characteristics. It was found that tensile strength, percentage elongation at break, and tensile modulus of PA 66/CB/MoS2 composite increased linearly with increase in MoS2 content. The impact strength of the PA 66 matrix increased from 37.2 to 43.2 J/m with an increase in MoS2 content. The wear behavior of PA 66/CB/MoS2 composites have been investigated under dry sliding conditions at different normal loads, sliding distances, and sliding velocities at room temperature. It was found that the introduction of MoS2 in the presence of CB has certainly reduced the friction, wear behavior of PA 66 with improvement in laser etching resistance. MoS2 could increase the adhesion between the transfer film and the counterface surface. The ability of the synergistic fillers in helping the formation of thin, uniform, and continuous transfer film would contribute to enhance the wear resistance of PA 66 composites. POLYM. ENG. SCI., 2013. © 2012 Society of Plastics EngineersKeywords
This publication has 32 references indexed in Scilit:
- An investigation of friction and wear performances of bonded molybdenum disulfide solid film lubricants in fretting conditionsWear, 2009
- Friction and Wear Mechanisms of Sintered and Thermoplastic Polyimides under Adhesive SlidingMacromolecular Materials and Engineering, 2007
- Polymeric Nanocomposites for Tribological ApplicationsMacromolecular Materials and Engineering, 2007
- Friction and wear studies using Taguchi method on polyphenylene sulfide filled with a complex mixture of MoS2, Al2O3, and other compoundsWear, 2005
- The Tribology of Composite Materials: A Preface1993
- Study of the friction and wear properties of MoS2-filled Nylon 6Wear, 1991
- Influence of fillers and fibre reinforcement on abrasive wear resistance of some polymeric compositesWear, 1990
- Dry bearings: a survey of materials and factors affecting their performanceTribology, 1973
- Polymer-based bearing materials—The role of fillers and fibre reinforcement in wearWear, 1972
- Nylon 6 as a bearing materialWear, 1962