Engine Experiments on the Effects of Design and Operational Parameters on Piston Secondary Motion and Piston Slap
Authors:
- 1 March 1994
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
Experiments were done to quantify the dynamic motion of the piston and oil-film during piston impact on the cylinder bore, commonly known as “piston slap.” Parameters measured include engine block vibration, piston-skirt to liner separation, oil-film thickness between the piston and liner, and other engine operating conditions. Experimental parametric studies were performed covering the following: engine operating parameters - spark timing, liner temperature, oil-film thickness, oil type, and engine speed; and engine design parameters - piston-skirt surface waviness, piston-skirt/cylinder-liner clearance, and wrist-pin offset. Two dynamic modes of piston-motion-induced vibration were observed, and effects of changes in engine operating and design parameters were investigated for both types of slap. It was evident that engine design parameters have stronger effects on piston slap intensity, with piston-skirt/liner clearance and wrist-pin offset being the dominant parameters. However, for given engine and component geometries, slap intensity was significantly affected by lubricant properties.Keywords
This publication has 10 references indexed in Scilit:
- A Numerical Model of Piston Secondary Motion and Piston Slap in Partially Flooded Elastohydrodynamic Skirt LubricationSAE International Journal of Advances and Current Practices in Mobility, 1994
- Development of Engine Lubricant Film Thickness Diagnostics Using Fiber Optics and Laser FluorescenceSAE International Journal of Advances and Current Practices in Mobility, 1992
- Vibration Due to Piston Slap and Combustion in Gasoline and Diesel EnginesSAE International Journal of Advances and Current Practices in Mobility, 1991
- Automotive Gasoline Engine Piston Noise, Sources and SolutionsSAE International Journal of Advances and Current Practices in Mobility, 1990
- Analysis and Reduction of Piston Slap Noise in Diesel EnginesSAE International Journal of Advances and Current Practices in Mobility, 1989
- Engineering The Spark-Ignition Engine - The Piston-Rings-Cylinder Wall InterfaceSAE International Journal of Advances and Current Practices in Mobility, 1988
- Acoustical Optimization of the Piston Slap by Combination of Computing and ExperimentsSAE International Journal of Advances and Current Practices in Mobility, 1988
- Piston Slap Motion and Engine Noise under Low Temperature Idling Operation of Diesel EnginesSAE International Journal of Advances and Current Practices in Mobility, 1983
- Engine Noise Due to Mechanical Impacts at Pistons and BearingsSAE International Journal of Advances and Current Practices in Mobility, 1980
- Analysis of Piston Slap-Induced Noise and Assessment of Some Methods of Control in Diesel EnginesSAE International Journal of Advances and Current Practices in Mobility, 1980