Optimization of Electrospray Deposition Conditions of ZnO Thin Films for Ammonia Sensing
Open Access
- 11 June 2024
- journal article
- research article
- Published by MDPI AG in Nanomaterials
- Vol. 14 (12) , 1008
Abstract
This study focuses on the influence of electrospray deposition parameters on the morphology, topography, optical and sensing properties of ZnO films deposited on gold electrodes of quartz crystal resonators. The substrate temperature, precursor feed rate and emitter’s voltage were varied. Zinc acetate dehydrate dissolved in a mixture of deionized water, ethanol and acetic acid was used as a precursor. The surface morphology and average roughness of the films were studied by scanning electron microscopy (SEM) and 3D optical profilometry, respectively, while the optical properties were investigated by diffuse reflectance and photoluminescence measurements. The sensing response toward ammonia was tested and verified by the quartz crystal microbalance (QCM) method. The studies demonstrated that electrospray deposition parameters strongly influence the surface morphology, roughness and gas sensing properties of the films. The deposition parameters were optimized in order for the highest sensitivity toward ammonia to be achieved. The successful implementation of the electrospray method as a simple, versatile and low-cost method for deposition of ammonia-sensitive and selective ZnO films used as a sensing medium in QCM sensors was demonstrated and discussed.Keywords
Funding Information
- National center of mechatronics and clean technologies (BG05M2OP001-1.001-0008-C01)
- European Regional Development Fund within the operational program “Science and Education for Smart Growth 2014–2020” (BG05M2OP001-1.001-0008-C01)
This publication has 45 references indexed in Scilit:
- Metal-oxide nanostructures produced by PLD in open air for gas sensor applicationsApplied Surface Science, 2019
- Influence of Al doping on the structural, morphological, optical, and gas sensing properties of ZnO nanorodsJournal of Alloys and Compounds, 2017
- DC-magnetron sputtering of ZnO:Al films on (00.1)Al2O3 substrates from slip-casting sintered ceramic targetsApplied Surface Science, 2014
- Aqueous chemical growth of free standing vertical ZnO nanoprisms, nanorods and nanodiskettes with improved texture co-efficient and tunable size uniformityApplied Physics A, 2011
- Site‐Specific Self‐Assembled Liquid‐Gated ZnO Nanowire Transistors for Sensing ApplicationsSmall, 2010
- ZnO Nanostructures for Dye‐Sensitized Solar CellsAdvanced Materials, 2009
- Polymer coated quartz crystal microbalance sensors for detection of volatile organic compounds in gas mixturesAnalytica Chimica Acta, 2007
- Nanostructure size evolution during Au-catalysed growth by carbo-thermal evaporation of well-aligned ZnO nanowires on (100)SiApplied Physics A, 2007
- States in the gapJournal of Non-Crystalline Solids, 1972
- Verwendung von Schwingquarzen zur W gung d nner Schichten und zur Mikrow gungThe European Physical Journal A, 1959