Evaluation of castability of high pressure die cast magnesium based alloys
Authors:
- 1 April 2010
- journal article
- research article
- Published by Maney Publishing in International Journal of Cast Metals Research
- Vol. 23 (2) , 81-91
Abstract
Alloy characteristics that impact on castability, such as hot tearing and fluidity, are as significant to the success of an alloy development program as the mechanical properties requirements of the final component. However, castability is often overlooked in the alloy development process and this could lead to substantial problems in fabrication. A new die has been developed to test multiple indicators of the high pressure die castability of an alloy. A rating system has been introduced to evaluate several exterior quality factors for high pressure die castings. This is coupled with selected metallographic inspection of the interior defects and the results are combined to compare the relative performance of different alloys. It was found that ZA124 alloy was the most castable of the alloys tested followed by AZ91 with the castability decreasing with decreasing Al content for Mg–Al based alloys.Keywords
This publication has 31 references indexed in Scilit:
- Defect Band Characteristics in Mg-Al and Al-Si High-Pressure Die CastingsMetallurgical and Materials Transactions A, 2007
- Hot cracking of binary Mg–Al alloy castingsMaterials Science and Engineering: A, 2006
- Characteristics of microstructure and banded defects in die cast AM50 magnesium componentsInternational Journal of Cast Metals Research, 2005
- Influence of variations in alloy composition on castability and process stability. Part 1: Gravity and pressure casting processesInternational Journal of Cast Metals Research, 2005
- Variability in the tensile ductility of high-pressure die-cast AM50 Mg-alloyScripta Materialia, 2005
- The Effect of Microstructural Features and Defects on the Ductility of High Pressure Die Cast AS21, AM60 and AZ91Materials Science Forum, 2003
- Quantitative characterization of spatial arrangement of shrinkage and gas (air) pores in cast magnesium alloysMaterials Characterization, 2001
- Hydrofluorocarbons as a Replacement for Sulphur Hexafluoride in Magnesium Processing2001
- New apparatus for characterising tensile strength development and hot cracking in the mushy zoneInternational Journal of Cast Metals Research, 2000
- Effect of grain refinement on the fluidity of two commercial Al-Si foundry alloysMetallurgical and Materials Transactions A, 1996