Adiabatic Effectiveness Measurements and Predictions of Leakage Flows Along a Blade Endwall
Authors:
- 18 January 2005
- journal article
- Published by Wiley in Journal of Turbomachinery
- Vol. 127 (3) , 609-618
Abstract
Traditional cooling schemes have been developed to cool turbine blades using high-pressure compressor air that bypasses the combustor. This high-pressure forces cooling air into the hot main gas path through seal slots. While parasitic leakages can provide a cooling benefit, they also represent aerodynamic losses. The results from the combined experimental and computational studies reported in this paper address the cooling benefit from leakage flows that occur along the platform of a first stage turbine blade. A scaled-up, blade geometry with an upstream slot, a mid-passage slot, and a downstream slot was tested in a linear cascade placed in a low-speed wind tunnel. Results show that the leakage flow through the mid-passage gap provides only a small cooling benefit to the platform. There is little to no benefit to the blade platform that results by increasing the coolant flow through the mid-passage gap. Unlike the mid-passage gap, leakage flow from the upstream slot provides good cooling to the platform surface, particularly in certain regions of the platform. Relatively good agreement was observed between the computational and experimental results, although computations overpredicted the cooling.Keywords
This publication has 14 references indexed in Scilit:
- Combustor Turbine Interface Studies—Part 2: Flow and Thermal Field MeasurementsJournal of Turbomachinery, 2003
- Turbine Nozzle Endwall Film Cooling Study Using Pressure-Sensitive PaintJournal of Turbomachinery, 2001
- Film-Cooled Turbine Endwall in a Transonic Flow Field: Part II—Heat Transfer and Film-Cooling EffectivenessJournal of Turbomachinery, 2001
- Effects of Slot Bleed Injection Over a Contoured Endwall on Nozzle Guide Vane Cooling Performance: Part I — Flow Field Measurements2000
- Heat Transfer and Flowfield Measurements in the Leading Edge Region of a Stator Vane EndwallJournal of Turbomachinery, 1999
- Turbulent Transport on the Endwall in the Region Between Adjacent Turbine BladesJournal of Heat Transfer, 1988
- Predictions of Endwall Losses and Secondary Flows in Axial Flow Turbine CascadesJournal of Turbomachinery, 1987
- An Experimental Study of Endwall and Airfoil Surface Heat Transfer in a Large Scale Turbine Blade CascadeJournal of Engineering for Power, 1980
- Three-Dimensional Flow Within a Turbine Cascade PassageJournal of Engineering for Power, 1977
- An Experimental Study of Heat Transfer and Film Cooling on Large-Scale Turbine EndwallsJournal of Heat Transfer, 1974