On the Friction Stir Welding of Al 7075 Thin Sheets
Open Access
Abstract
The aim of this work was to weld thin sheets (2 mm) of Al 7075 in a butt joint configuration using friction stir welding and to identify the appropriate tool geometry and optimum process parameters. Two tools were produced with heat treatable low alloy steel WNr 1.6582/DIN 34CrNiMo6 with a different pin diameter (3 mm and 4 mm). Welding was performed at a range of rotation speeds 1000–2500 rpm and various welding speeds 80–800 mm/min. The tensile strength was measured to evaluate mechanical properties. Results showed that despite the difficulties in friction stir welding thin plates, sound joints can be produced in a repeatable manner, without visible wear on the welding tool. The mechanical strength of the welds showed a decrease (33.75%) over that of the parent material. The mechanical strength was less affected by rotation speed than welding speed and there was a significant decrease in tensile strength compared to the parent material.Keywords
This publication has 19 references indexed in Scilit:
- Rotary friction welding on dissimilar metals of aluminum and brass by using pre-heating methodThe International Journal of Advanced Manufacturing Technology, 2018
- Joining of magnesium and aluminum alloys via ultrasonic assisted friction stir welding at low temperatureThe International Journal of Advanced Manufacturing Technology, 2018
- Emerging Friction Stir Welding for Aluminium and its ApplicationsManufacturing and Industrial Engineering, 2015
- Influence of aluminium alloy type on dissimilar friction stir lap welding of aluminium to copperJournal of Materials Processing Technology, 2013
- Friction Stir Welding of very thin platesSoldagem & Inspeção, 2012
- Friction stir welded structural materials: beyond Al-alloysInternational Materials Reviews, 2011
- Weldability and mechanical properties of dissimilar aluminum–copper lap joints made by friction stir weldingJournal of Alloys and Compounds, 2010
- Friction stir welding and processingMaterials Science and Engineering: R: Reports, 2005
- Hot cracking in Al–Mg–Si alloy laser welding – operating parameters and their effectsMaterials Science and Engineering: A, 2005
- Properties of friction-stir-welded 7075 T651 aluminumMetallurgical and Materials Transactions A, 1998