Transforming Waste Red-Bed Mudstone into Sustainable Controlled Low-Strength Materials: Mix Design for Enhanced Engineering Performance
Open Access
Abstract
Red-bed mudstone from civil excavation is often treated as waste due to its poor water stability and tendency to disintegrate. This study proposes a sustainable approach for its utilization in controlled low-strength material (CLSM) by blending it with cement and water. Laboratory tests evaluated the fresh properties (i.e., flowability, bleeding rate, setting time, and subsidence rate) and hardened properties (i.e., compressive strength, drying shrinkage, and wet–dry durability) of the CLSM. The analysis focused on two main parameters: cement-to-soil ratio (C/S) and water-to-solid ratio (W/S). The results show that increasing W/S significantly improves flowability, while increasing C/S also contributes positively. Flowability decreased exponentially over time, with an approximately 30% loss recorded after 3 h. Bleeding and subsidence rates rose sharply with higher W/S but were only marginally affected by C/S. To meet performance requirements, W/S should be kept below 52%. In addition, the setting times remained within 24 h for all mixtures tested. Compressive strength showed a negative correlation with W/S and a positive correlation with C/S. When C/S ranged from 8% to 16% and W/S from 44% to 56%, the compressive strengths ranged from 0.3 MPa to 1.22 MPa, meeting typical backfilling needs. Drying shrinkage was correlated positively with water loss, and it decreased with greater C/S. Notably, cement’s addition significantly enhanced water stability. At a C/S of 12%, the specimens remained intact after 13 wet–dry cycles, retaining over 80% of their initial strength. Based on these findings, predictive models for strength and flowability were developed, and a mix design procedure was proposed. This resulted in two optimized proportions suitable for confined backfilling. This study provides a scientific basis for the resource-oriented reuse of red-bed mudstone in civil engineering projects.Keywords
Funding Information
- Major Program of the Natural Science Foundation of Sichuan Province of China (2024NSFSC0003, 2024GD-Z02, B21011)
- Foundation of Sichuan Engineering Research Center for Intelligent Operation and Maintenance of Rail Transit Lines, Chengdu Vocational & Technical College of Industry (2024NSFSC0003, 2024GD-Z02, B21011)
- Higher Education Discipline Innovation Project (2024NSFSC0003, 2024GD-Z02, B21011)
This publication has 37 references indexed in Scilit:
- Effect of carbonation curing on the characterization and properties of steel slag-based cementitious materialsCement and Concrete Composites, 2024
- The effect of coarse aggregate on the bleeding and mechanical properties of cemented paste backfillJournal of Central South University, 2023
- A comprehensive review on mechanical properties of green controlled low strength materialsConstruction and Building Materials, 2022
- Engineering properties of soil-based controlled low-strength materials made from local red mud and silty soilConstruction and Building Materials, 2022
- On the origin of bleaching phenomena in red bed sediments of Triassic Buntsandstein deposits in Central GermanyGeochemistry, 2021
- Rapid-hardening controlled low strength materials made of recycled fine aggregate from construction and demolition wasteConstruction and Building Materials, 2018
- How Does the European Recovery Target for Construction & Demolition Waste Affect Resource Management?Waste and Biomass Valorization, 2016
- Development of controlled low-strength material derived from beneficial reuse of bottom ash and sediment for green constructionConstruction and Building Materials, 2014
- Engineering properties of controlled low-strength materials containing waste oyster shellsConstruction and Building Materials, 2013
- Environmental effects on durability of soil stabilized with recycled gypsumCold Regions Science and Technology, 2011