Interfacial properties of the brine + carbon dioxide + oil + silica system
Open Access
- 18 March 2024
- journal article
- research article
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 160 (11)
Abstract
Molecular dynamics simulations of the H2O + CO2 + aromatic hydrocarbon and H2O + CO2 + benzene + silica (hydrophilic) systems are performed to gain insights into CO2-enhanced oil recovery (EOR) processes. For comparison purposes, an overview of the previous simulation studies of the interfacial properties of the brine + CO2 + alkane + silica system is also presented. In general, the water contact angle (CA) of the H2O + CO2 + silica (hydrophilic) system increased with pressure and decreased with temperature. The CAs of the H2O + hydrocarbon + silica (hydrophilic) system are not significantly affected by temperature and pressure. The simulated CAs were in the ranges of about 58°–77° and 81°–93° for the H2O + hexane + silica (hydrophilic) and the H2O + aromatic hydrocarbon + silica (hydrophilic) systems, respectively. In general, these CAs were not significantly influenced by the addition of CO2. The simulated CAs were in the ranges of about 51.4°–95.0°, 69.1°–86.0°, and 72.0°–87.9° for the brine + CO2 + silica (hydrophilic), brine + hexane + silica (hydrophilic), and brine + CO2 + hexane + silica (hydrophilic) systems, respectively. All these CAs increased with increasing NaCl concentration. The adhesion tension of the brine + silica (hydrophilic) system in the presence of CO2 and/or hexane decreased with increasing salt concentration. The simulated CAs were in the range of about 117°–139° for the H2O + alkane + silica (hydrophobic) system. These CAs are increased by the addition of CO2. At high pressures, the distributions of H2O normal to the silica (hydrophobic) surface in the droplet region of the H2O + silica system were found to be strongly affected by the presence of CO2. These insights might be key for optimizing the performance of the miscible CO2 water-alternating-gas injection schemes widely used for EOR.Keywords
Funding Information
- King Abdullah University of Science and Technology (ORFS-2022-CRG11-5028)
- Youth Science Fund Project (42203041)
- Natural Science Foundation of Jiangsu Province (BK20221132)
This publication has 59 references indexed in Scilit:
- Atomistic prediction on the degradation of vinylester-based composite under chloride and elevated temperatureComposites Science and Technology, 2022
- Interfacial properties of the alkane+water system in the presence of carbon dioxide and hydrophobic silicaFuel, 2022
- Molecular dynamics simulation of the interfacial wetting behavior of brine/sandstone with different salinitiesColloids and Surfaces A: Physicochemical and Engineering Aspects, 2022
- Mechanisms for kerogen wettability transition from water-wet to CO2-wet: Implications for CO2 sequestrationChemical Engineering Journal, 2022
- Molecular dynamics simulations on adhesion of epoxy-silica interface in salt environmentComposites Part B: Engineering, 2017
- Molecular Dynamics Simulation of Water/CO2-quartz Interfacial Properties: Application to Subsurface Gas InjectionEnergy Procedia, 2013
- On the influence of sodium chloride concentration on equilibrium contact angleChemical Engineering Journal, 2006
- Fast Parallel Algorithms for Short-Range Molecular DynamicsJournal of Computational Physics, 1995
- Interfacial tension between water and non‐polar fluids up to 473 K and 2800 barBerichte der Bunsengesellschaft für physikalische Chemie, 1994
- The effect of temperature and pressure on the interfacial tension of benzene-water and normal decane-waterJournal of Colloid and Interface Science, 1967