In Situ Concrete Bridge Strengthening Using Ductile Activated NSMR CFRP System
Open Access
- 16 December 2022
- Vol. 12 (12) , 2244
Abstract
Novel and complex structural solutions are often challenging to introduce in the building industry since they may provide unconventional and less verified behavior combined with several novel and unique failure modes. A desired safety level may be difficult to verify due to the lack of knowledge related to failure modes and their variation. This study introduces a method that may provide a first step toward addressing such challenges. Five laboratory tests were done on a novel ductile response-controlled anchor system used for prestressed CFRP NSMR strengthening. These results were used as a basis for further implementation in a pilot project where an in situ cast concrete bridge was strengthened with the developed system. A particular focus was dedicated to the capability of the designed system response to provide a consistent load/deformation curve, yielding threshold, and yielding regime. The novel system enabled response tailoring to the specific pilot project. Installation and prestressing procedure worked as desired, where losses in the fully prestressed system, after three weeks, were approximately 0.2 to 1.6 kN (0.2–1.3 mm). In situ proof loading of all strengthening systems (20 anchor systems) was done to eliminate any possible failure modes below the proof-loading level. It was performed with no signs of distress.Keywords
This publication has 36 references indexed in Scilit:
- Review of Anchorage Systems for Externally Bonded FRP LaminatesInternational Journal of Concrete Structures and Materials, 2013
- Mechanical anchorage of FRP tendons – A literature reviewConstruction and Building Materials, 2012
- Failure modes and failure mechanisms of RC members strengthened by NSM CFRP composites – Analysis of pull-out failure modeComposites Part B: Engineering, 2012
- Efficiency of different techniques in flexural strengthening of RC beams under monotonic and fatigue loadingConstruction and Building Materials, 2012
- Transversely compressed bonded jointsComposites Part B: Engineering, 2012
- Flexural behaviour of reinforced concrete beams strengthened with prestressed carbon compositesComposite Structures, 2009
- Interfacial stress transfer of near surface-mounted FRP-to-concrete jointsEngineering Structures, 2008
- The predictive capability of failure mode concept-based strength criteria for multidirectional laminatesComposites Science and Technology, 2004
- Intermediate crack-induced debonding in RC beams and slabsConstruction and Building Materials, 2003
- North American design guidelines for concrete reinforcement and strengthening using FRP: principles, applications and unresolved issuesConstruction and Building Materials, 2003