Evolution of Thin-Liquid Films Surrounding Bubbles in Microfluidics and Their Impact on the Pressure Drop and Fluid Movement
- 6 December 2020
- journal article
- research article
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 36 (49) , 15102-15111
Abstract
The evolution of thin-liquid films in a microchannel is one of the most critical and intricate phenomena to understand two-phase movement, evaporation, micromixing, heat transfer, chemical synthesis, biological processes, and efficient energy devices. In this paper, we demonstrate experimentally the effect of a liquid film on the removal of an initially dry and lodged bubble in laser-etched poly(methyl methacrylate) microfluidic networks and discuss the evolution of the liquid film in accordance with the bubble superficial velocity and the effect of liquid properties and branch angle on the evolution of the liquid film and the pressure drop. During the removal of a dry bubble, four stages have been observed in the bubble velocity profile and they directly relate to the evolution of the liquid film. The correlation of maximum bubble velocity has been derived as a function of bubble length, fluid viscosity, surface tension, geometry of the cross-sectional area, and dimensions of the microchannel and agrees with the experimental results. The bubble moving distance required for the full deposition of a continuous and stable thin-liquid film is affected by the liquid viscosity and network branch angle. The liquid with a higher viscosity will increase the pressure drop for removing dry bubbles from microfluidic networks, while this effect will be hampered by increasing the microfluidic network complexity. The deposition of the thin-liquid film surrounding bubbles significantly decreases the pressure drop required to remove bubbles from microfluidics. Compared with deionized water, the glycerol solution is prone to acting as the lubricating liquid due to its strong H-bond interaction with the channel wall and the reduction in interfacial energy of the gas–water interface.Keywords
Funding Information
- Engineering and Physical Sciences Research Council (UK?[EP/N024672/1])
- UK-India Education and Research Initiative
This publication has 48 references indexed in Scilit:
- Film thickness measurements in liquid–liquid slug flow regimesInternational Journal of Heat and Fluid Flow, 2013
- Measurement of the liquid film thickness in micro tube slug flowInternational Journal of Heat and Fluid Flow, 2009
- Capillary microreactors wall-coated with mesoporous titania thin film catalyst supportsLab on a Chip, 2008
- Multiphase microfluidics: from flow characteristics to chemical and materials synthesisLab on a Chip, 2006
- Measurement of liquid film in microchannels using a laser focus displacement meterExperiments in Fluids, 2005
- Quick deposition of a fluid on the wall of a tubePhysics of Fluids, 2000
- Multiphase flow and transport modeling in heterogeneous porous media: challenges and approachesAdvances in Water Resources, 1998
- Simultaneous heat and mass transfer in film absorption under laminar flowInternational Journal of Heat and Mass Transfer, 1983
- Rupture of thin liquid films due to spontaneous fluctuations in thicknessJournal of the American Chemical Society, 1968
- Significance of Liquid-Film Coefficients in Gas AbsorptionIndustrial & Engineering Chemistry, 1951