Electrode kinetics of the NiO porous electrode for oxygen production in the molten carbonate electrolysis cell (MCEC)
- 5 February 2015
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Faraday Discussions
- Vol. 182, 493-509
Abstract
The performance of a molten carbonate electrolysis cell (MCEC) is to a great extent determined by the anode, i.e. the oxygen production reaction at the porous NiO electrode. In this study, stationary polarization curves for the NiO electrode were measured under varying gas compositions and temperatures. The exchange current densities were calculated numerically from the slopes at low overpotential. Positive dependency on the exchange current density was found for the partial pressure of oxygen. When the temperature was increased in the range 600–650 °C, the reaction order of oxygen decreased from 0.97 to 0.80. However, there are two different cases for the partial pressure dependency of carbon dioxide within this temperature range: positive values, 0.09–0.30, for the reaction order at lower CO 2 concentration, and negative values, −0.26–0.01, with increasing CO 2 content. A comparison of theoretically obtained data indicates that the oxygen-producing reaction in MCEC could be reasonably satisfied by the reverse of oxygen reduction by the oxygen mechanism I, an n = 4 electron reaction, assuming a low coverage of oxide ions at high CO 2 content and an intermediate coverage for a low CO 2 concentration.Keywords
This publication has 21 references indexed in Scilit:
- Conversion of CO[sub 2] to CO by Electrolysis of Molten Lithium CarbonateJournal of the Electrochemical Society, 2010
- The carbon dioxide concentrator by using MCFCJournal of Power Sources, 2003
- CO[sub 2] Dissolution into a 52/48 Mol % Li/Na Carbonate Melt and the Molten Carbonate Fuel Cell CathodeJournal of the Electrochemical Society, 2000
- CO2 reduction in molten 62/38 mole% Li/K carbonate mixtureElectrochimica Acta, 1998
- The Effects of Oxidant Gas Composition on the Polarization of Porous LiCoO2 Electrodes for the Molten Carbonate Fuel CellJournal of the Electrochemical Society, 1997
- The Polarization of Molten Carbonate Fuel Cell Electrodes: I . Analysis of Steady‐State Polarization DataJournal of the Electrochemical Society, 1991
- The Polarization of Molten Carbonate Fuel Cell Electrodes: II . Characterization by AC Impedance and Response to Current InterruptionJournal of the Electrochemical Society, 1991
- Influence of Chemical Equilibria on Oxygen Reduction Reaction in Molten CarbonateJournal of the Electrochemical Society, 1990
- The Effect of Oxidant Composition on the Performance of Molten Carbonate Fuel CellsJournal of the Electrochemical Society, 1988
- A Homogeneous/Agglomerate Model for Molten Carbonate Fuel Cell CathodesJournal of the Electrochemical Society, 1984