Experimental Investigation of Aluminum Alloy Thin-Walled Tubular Members in Combined Compression and Bending
Authors:
- 1 December 2006
- journal article
- Published by American Society of Civil Engineers (ASCE) in Journal of Structural Engineering
- Vol. 132 (12) , 1955-1966
Abstract
This paper presents a test program on aluminum alloy thin-walled square and rectangular hollow sections in combined axial compression and minor axis bending. A total of six series of tests was conducted that included 27 beam-column and 4 pure bending tests. The test specimens were manufactured by extrusion using 6061-T6 heat-treated aluminum alloy in three different cross sections having the clear width-to-thickness ratio ranged from 31.3 to 81.3. The beam-column specimens were compressed between pinned ends at different eccentricities in order to obtain an interaction curve for each series of tests. Pure bending tests were conducted for each test series to determine the bending capacities of the specimens. Local and overall initial geometric imperfections of the specimens were measured. Material properties were obtained from tensile coupon tests. The observed failure modes of the beam-column tests included local buckling, flexural buckling, interaction of local and flexural buckling, and material yieldin...Keywords
This publication has 4 references indexed in Scilit:
- Tests and Design of Aluminum Alloy Compression MembersJournal of Structural Engineering, 2006
- Thin-Walled Beam-Columns. I: Sequential Loading and Moment Gradient TestsJournal of Structural Engineering, 1999
- Behavior of Cold-Formed SHS Beam-ColumnsJournal of Structural Engineering, 1996
- Eccentrically Loaded Aluminum ColumnsTransactions of the American Society of Civil Engineers, 1955