Force analysis of the patellar mechanism
Authors:
- 1 January 1987
- journal article
- research article
- Published by Wiley in Journal of Orthopaedic Research
- Vol. 5 (1) , 69-85
Abstract
The aim of this study is an experimental evaluation of a force analysis of the patellar mechanism based on the assumption that patellofemoral contact is frictionless. At first, the geometric characteristics of contact surfaces, a prior knowledge of which is necessary for quantitative analysis, were measured from radiographs of 42 fresh‐frozen knee specimens in the flexion range 0–120°. The results were then used in the analysis to predict the relations between the forces acting on the patella. For the evaluation of the analysis, the ratio of the tension in the ligamentum patellae and the rectus femoris was measured in ten specimens during simulation of two knee functions: (1)“leg raising” against a resistance; and (2)“static lifiting”. The effect of flexion angle on the ratio is found to be rather complex. With increasing flexion, the ratio increases initially up to 30°, then decreases up to 90°, and finally increases again beyond 90°. The ratio is above unity up to around 45° and below that in the remaining flexion range. The analysis has been found to predict not only the characteristic variation of the ratio but also its magnitude with reasonable accuracy. It has been concluded that for an accurate prediction of the patellofemoral joint reaction, the force analysis needs to be based on the geometry of the contact surfaces. This implies that the mechanical consequences of surgical procedures involving tibial tubercle relocation cannot be inferred simply on the basis of their effect on the patellar mechanism angle, but that they also require consideration of their effect on the contact geometry.Keywords
This publication has 22 references indexed in Scilit:
- Design and Performance of a Modified Buckle Transducer for the Measurement of Ligament TensionJournal of Biomechanical Engineering, 1986
- Model for static lifting: Relationship of loads on the spine and the kneeJournal of Biomechanics, 1984
- Force ratios in the quadriceps tendon and ligamentum patellaeJournal of Orthopaedic Research, 1984
- In-Vitro Measurement of Static Pressure Distribution in Synovial Joints—Part II: Retropatellar SurfaceJournal of Biomechanical Engineering, 1983
- An Evaluation of the Ratio between the Tensions along the Quadriceps Tendon and the Patellar LigamentEngineering in Medicine, 1980
- Forces in the Knee Joint Whilst Rising from Normal and Motorized ChairsEngineering in Medicine, 1979
- A Note on the Ratio between Tensions in the Quadriceps Tendon and Infra-Patellar LigamentEngineering in Medicine, 1977
- QUADRICEPS FEMORIS STRENGTHRheumatology, 1973
- Isometric Knee Extension Strength as a Function of Joint Angle, Muscle Length and Motor Unit ActivityActa Orthopaedica, 1972
- Knee Extension:Measurement of the Isometric Force in Different Positions of the Knee-JointActa Orthopaedica, 1969