Modeling Heavy-Duty Engine Thermal Management Technologies to Meet Future Cold Start Requirements
Authors:
- 2 April 2019
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
The low-NOx standard for heavy-duty trucks proposed by the California Air Resources Board will require rapid warm-up of the aftertreatment system. Several different engine technologies are being considered to meet this need. In this study, a 1-D engine model was first used to evaluate several individual control strategies capable of increasing the exhaust enthalpy and decreasing the engine-out NOX over the initial portion of the cold start FTP cycle. The additional fuel consumption resulting from these strategies was also quantified with the model. Next, several of those strategies were combined to create a hypothetical aftertreatment warm-up mode for the engine. The model was then used to evaluate potential benefits of an air gap manifold (AGM) and two different turbine by-pass architectures. The detailed geometry of the AGM model was taken into account, having been constructed from a real prototype design. An equally detailed manifold model consisting of a single thick layer with the thermal properties of cast iron served as the baseline. The AGM provided ~30°C increase in temperature and a 13% increase in enthalpy over the first 300 seconds of the cold FTP, which is only about 20% of the impact of the warm-up mode, but is achieved with no additional fuel consumption. The turbine by-pass concepts were not as effective as the AGM, primarily because the by-pass flow rate must be limited during the early loaded periods of the FTP in order to meet the torque demand of the test.Keywords
This publication has 10 references indexed in Scilit:
- Modeling of Close-Coupled SCR Concepts to Meet Future Cold Start Requirements for Heavy-Duty EnginesSAE International Journal of Advances and Current Practices in Mobility, 2019
- Holistic Development of Future Low NO x Emission Concepts for Heavy-Duty ApplicationsSAE International Journal of Advances and Current Practices in Mobility, 2018
- Variable Ventiltriebe in Heavy-Duty-Motoren – ermittelte Potenziale mit Miller-Steuerzeiten2018
- Achieving Ultra Low NO X Emissions Levels with a 2017 Heavy-Duty On-Highway TC Diesel Engine and an Advanced Technology Emissions System - NO X Management StrategiesSAE International Journal of Engines, 2017
- Achieving Ultra Low NO X Emissions Levels with a 2017 Heavy-Duty On-Highway TC Diesel Engine and an Advanced Technology Emissions System - Thermal Management StrategiesSAE International Journal of Engines, 2017
- Achieving Ultra Low NOX Emissions Levels with a 2017 Heavy-Duty On-Highway TC Diesel Engine - Comparison of Advanced Technology ApproachesSAE International Journal of Engines, 2017
- Phenomenological modeling of combustion and NOx emissions using detailed tabulated chemistry methods in diesel enginesInternational Journal of Engine Research, 2016
- Miller Valve Timing for Future Commercial Diesel EnginesMTZ Worldwide, 2015
- Investigation of VVA-Based Exhaust Management Strategies by Means of a HD Single Cylinder Research Engine and Rapid Prototyping SystemsSAE International Journal of Commercial Vehicles, 2013
- Mercedes-Benz Medium-Duty Commercial EnginesMTZ Worldwide, 2012