Novel overmode circular waveguide bend for high power tm01 mode transmission
Authors:
- 1 July 2017
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 2223-2224
Abstract
A novel structure of overmode circular waveguide bend is investigated, which is used to transmitter circular waveguide TM 01 mode with high power-handing capacity, high transmission efficiency and small bend radius. Metal plates and metal rod are used to change the type of waveguide. In the bend of the structure, circular waveguide is split into four sector waveguides, and the phase difference between sector waveguide TE 11 modes changes from 0 to 2π, that means the phases of sector waveguide TE 11 modes are also same after bending. Four sector waveguide TE 11 modes with same phase convert to coaxial TEM mode at the end of the metal plates, which finally converts to circular waveguide TM 01 mode and is outputted. Microwave propagates with singlemode in the bend of the structure, that can avoid exciting high-order mode. Experimental test results show that VSWR is below 1.3 in the range of 8.25-8.55 GHz and less than 1.07 at 8.4 GHz and the insertion loss is 0.2 dB at 8.4 GHz, which prove the feasibility of the structure of the overmode circular waveguide bend.Keywords
This publication has 3 references indexed in Scilit:
- A novel TEM-TE/sub 11/ mode converterIEEE Microwave and Wireless Components Letters, 2005
- High-Power Microwave Sources and Technologies2001
- Modeling of discontinuities in general coaxial waveguide structures by the FDTD-methodIEEE Transactions on Microwave Theory and Techniques, 1992