The effect of heat treatment on the mechanical properties of a low carbon steel (0.1%) for offshore structural application
Authors:
- 25 April 2012
- journal article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part L: Journal of Materials: Design and Applications
- Vol. 226 (3) , 242-251
Abstract
In this study, a low carbon cast steel (0.1% C) alloy designed for offshore structures, and the mechanical properties of the alloy under different heat treatment cycles have been evaluated. The effect of austenitizing time on the austenite grain size was studied. Subsequently, the quenched samples with minimum austenite grain size subjected to tempering experiments at different tempering temperatures (450 °C, 550 °C, and 650 °C) and cooling rates (0.23, 36, and 50 °C/s) from the temperature. The results showed that by increasing the austenitizing time, the austenite grain size initially decreased and reached the minimum value with ASTM number of 6.35 and then followed by an increase. When the tempering temperature increased, yield and tensile strengths decreased, whereas the ductility properties improved. In addition, yield and tensile strengths were not affected by cooling rate from tempering temperature, whereas the ductility properties were slightly affected. The increase in tempering temperature significantly led to improvement in the toughness to fracture of the alloy. The effect of cooling rate on impact energy for the samples tempered at 450 °C and 550 °C was negligible. By the contrast, impact energy for the samples tempered at 650 °C was markedly affected by cooling rate, in which the highest value was achieved for a cooling rate of 50 °C/s.Keywords
This publication has 15 references indexed in Scilit:
- The effect of heat treatment on mechanical properties and corrosion behavior of AISI420 martensitic stainless steelJournal of Alloys and Compounds, 2011
- Austenite Formation in Plain Low-Carbon SteelsMetallurgical and Materials Transactions A, 2010
- Steel Heat Treatment Handbook - 2 Volume Set2006
- Effects of Cr, Cu, Ni and Ca on the corrosion behavior of low carbon steel in synthetic tap waterJournal of Alloys and Compounds, 2005
- Metallographic techniques for the determination of the austenite grain size in medium-carbon microalloyed steelsMaterials Characterization, 2001
- Martensite in steel: strength and structureMaterials Science and Engineering: A, 1999
- The effect of weld geometry and residual stresses on the fatigue of welded joints under combined loadingJournal of Materials Processing Technology, 1998
- Formation of Austenite During Intercritical Annealing of Dual-Phase SteelsMetallurgical Transactions A, 1981
- The tempering of Fe-C lath martensiteMetallurgical Transactions, 1972
- Tempering of steelMetallurgical Transactions, 1972