A 13.8-ENOB Fully Dynamic Third-Order Noise-Shaping SAR ADC in a Single-Amplifier EF-CIFF Structure With Hardware-Reusing kT/C Noise Cancellation
Top Cited Papers
- 9 September 2021
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 56 (12) , 3668-3680
Abstract
To design noise-shaping successive approximation register (NS-SAR) analog-to-digital converters (ADCs) with high resolution and good power efficiency, two key bottlenecks need to be addressed. One is to realize a high-order loop filter with low circuit overhead, and the other is to mitigate the thermal noise. This article presents an NS-SAR ADC that synergistically addresses both challenges. To achieve high-order efficiency, it proposes an innovative error feedback-cascaded integrator feedforward (EF-CIFF) structure that realizes third-order noise shaping using only a single amplifier. It combines the merits of both structures, showing improved robustness, and is free of dc offset concern. On reducing the kT/C noise, this work features a sampling kT/C noise cancellation (SNC) technique that reuses the native hardware of the EF-CIFF structure. An open-loop self-quenching floating-inverter dynamic amplifier (FIDA) is used to support all amplification with low noise and power. Prototyped in 65-nm CMOS, this work achieves 84.8-dB signal-to-noise-distortion ratio (SNDR) with 625-kHz bandwidth (BW) (OSR = 8) and 119 $\mu \text{W}$ , leading to 182-dB Schreier Figure of Merit (FoM). It uses only 0.8-pF input capacitance, which is $5\times $ smaller than prior NS-SAR ADCs with similar oversampling ratio (OSR) and SNDR.Keywords
This publication has 23 references indexed in Scilit:
- A 2.4-mW 25-MHz BW 300-MS/s passive noise shaping SAR ADC with noise quantizer technique in 14-nm CMOS2017
- An 11.0 bit ENOB, 9.8 fJ/conv.-step noise-shaping SAR ADC calibrated by least squares estimation2017
- 28.1 A 0.46mW 5MHz-BW 79.7dB-SNDR noise-shaping SAR ADC with dynamic-amplifier-based FIR-IIR filter2017
- A 2nd order fully-passive noise-shaping SAR ADC with embedded passive gain2017
- An Oversampling SAR ADC With DAC Mismatch Error Shaping Achieving 105 dB SFDR and 101 dB SNDR Over 1 kHz BW in 55 nm CMOSIEEE Journal of Solid-State Circuits, 2016
- A 9.35-ENOB, 14.8 fJ/conv.-step fully-passive noise-shaping SAR ADC2015
- A 7.2 mW 75.3 dB SNDR 10 MHz BW CT delta-sigma modulator using Gm-C-based noise-shaped quantizer and digital integrator2015
- Sampling Circuits That Break the kT/C Thermal Noise LimitIEEE Journal of Solid-State Circuits, 2014
- An 8.1 mW, 82 dB Delta-Sigma ADC With 1.9 MHz BW and $-$98 dB THDIEEE Journal of Solid-State Circuits, 2009
- A 12-Bit, 10-MHz Bandwidth, Continuous-Time $\Sigma\Delta$ ADC With a 5-Bit, 950-MS/s VCO-Based QuantizerIEEE Journal of Solid-State Circuits, 2008