Comparative Analysis of Molded and Drilled Holes in Jute Fiber Reinforced Plastic Laminates
- 14 July 2021
- journal article
- research article
- Published by Taylor & Francis in Journal of Natural Fibers
- Vol. 19 (14) , 7363-7373
Abstract
Natural Fiber Reinforced Composites (NFRCs) are an important class of materials that have the potential to facilitate the global goals of sustainability and environment protection. In order to fully realize the potential of these materials, it is important to ascertain their good quality and cost-effective manufacturing. Although the primary manufacturing techniques for fabricating the products based on NFRCs are well developed, their secondary manufacturing in terms of machining and joining still requires extensive research efforts. Drilling induced damage is the major cause of rejection of composite products with holes. In the current experimental investigation, the efficacy of producing the holes during the molding stage has been investigated. The mechanical performance of the molded holes has been compared with the drilled holes in jute fiber reinforced epoxy/polyester composite laminates, in terms of open hole, filled hole, and bearing tests. The values of the maximum tensile load recorded during the tests have been compared and it has been found that the molded holes perform better than the drilled holes for both types of materials (jute/epoxy, jute/polyester). Also, the load extension curves suggest that the molded holes undergo larger extension as compared to the drilled holes.Keywords
This publication has 18 references indexed in Scilit:
- Hole making in natural fiber-reinforced polylactic acid laminatesJournal of Thermoplastic Composite Materials, 2016
- Drilling Characteristics of Sisal Fiber-Reinforced Epoxy and Polypropylene CompositesMaterials and Manufacturing Processes, 2014
- Delamination Analysis in Drilling of Coir-Polyester Composites Using Design of ExperimentsAdvanced Materials Research, 2014
- Drilling behavior of sisal fiber-reinforced polypropylene composite laminatesJournal of Reinforced Plastics and Composites, 2013
- Drilling Uni-Directional Fiber-Reinforced Plastics Manufactured by Hand Lay-Up Influence of FibersAmerican Journal of Materials Science and Technology, 2012
- Regression modeling and optimization of machinability behavior of glass-coir-polyester hybrid composite using factorial design methodologyThe International Journal of Advanced Manufacturing Technology, 2010
- Optimization of thrust force, torque, and tool wear in drilling of coir fiber-reinforced composites using Nelder–Mead and genetic algorithm methodsThe International Journal of Advanced Manufacturing Technology, 2010
- Comparison of Tensile Strength of Composite Material Elements with Drilled and Molded-in HolesApplied Composite Materials, 2008
- Compression behaviour of woven carbon fibre-reinforced epoxy composites with moulded-in and drilled holesComposites, 1990
- Notched strength of woven fabric composites with moulded-in holesComposites, 1987