Deflection of Densified Beech and Aspen Woods as a Function of Selected Factors
Open Access
- 2 February 2017
- journal article
- Published by BioResources in BioResources
- Vol. 12 (2) , 3192-3210
Abstract
Effects of selected factors (wood species (Beech, Aspen), degree of densification (10%, 20%), material thickness (4 mm, 6 mm, 10 mm, and 18 mm), and number of loading cycles (0, 10,000)) were analyzed relative to the bendability of densified wood. The monitored characteristics were the deflection at proportional limit (YE), deflection at maximum limit (YP), and their ratio (YE:YP). One of the main causes of unfavorable wood bending is its low deflection under tensile stress parallel to the fiber in comparison to compressive stress in the same direction. From the results it is clear that the deflection at the proportionality limit depended on all monitored factors. The deflection at the yield point was not influenced by cyclic loading, and the ratio of deflection was influenced by material thickness only. Based on this ratio, the moulding properties of material can be identified. There was a strong correlation between the two deflection limits. The results are an important foundation for progress in the production of laminated materials with specific properties for intended use.Keywords
This publication has 14 references indexed in Scilit:
- Bendability characteristics of wood lamellae in plastic regionComposite Structures, 2017
- Coefficient of wood bendability as a function of selected factorsConstruction and Building Materials, 2016
- Stress simulation in layered wood-based materials under mechanical loadingMaterials & Design, 2015
- Influence of Densification on Bending Strength of Laminated Beech WoodBioResources, 2014
- Micromorphological studies of surface densified woodJournal of Materials Science, 2013
- FEM simulation of the hygro-thermal behaviour of wood under surface densification at high temperatureJournal of Materials Science, 2013
- The pliability of wood and its application to moldingJournal of Materials Processing Technology, 2009
- Semi-isostatic densification of heat-treated radiata pineWood Science and Technology, 2007
- Material behaviour of veneer during multidimensional mouldingEuropean Journal of Wood and Wood Products, 2005
- Effects of semi-isostatic densification of wood on the variation in strength properties with densityWood Science and Technology, 2005