Study on factors affecting the droplet temperature in plasma MIG welding process
- 12 March 2018
- journal article
- research article
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 51 (13) , 135206
Abstract
In the present study, the mechanism to control droplet temperature in the plasma MIG welding was discussed based on the measurements of the droplet temperature for a wide range of MIG currents with different plasma electrode diameters. The measurements of the droplet temperatures were conducted using a two color temperature measurement method. The droplet temperatures in the plasma MIG welding were then compared with those in the conventional MIG welding. As a result, the droplet temperature in the plasma MIG welding was found to be reduced in comparison with the conventional MIG welding under the same MIG current. Especially when the small plasma electrode diameter was used, the decrease in the droplet temperature reached maximally 500 K. Also, for a particular WFS, the droplet temperatures in the plasma MIG welding were lower than those in the conventional MIG welding. It is suggested that the use of plasma contributes to reducing the local heat input into the base metal by the droplet. The presence of the plasma surrounding the wire is considered to increase the electron density in its vicinity, resulting in the arc attachment expanding upwards along the wire surface to disperse the MIG current. This dispersion of MIG current causes a decrease in current density on the droplet surface, lowering the droplet temperature. Furthermore, dispersed MIG current also weakens the electromagnetic pinch force acting on the neck of the wire above the droplet. This leads to a larger droplet diameter with increased surface area through lower frequency of droplet detachment to decrease the MIG current density on the droplet surface, as compared to the conventional MIG welding at the same MIG current. Thus, the lower droplet temperature is caused by the reduction of heat flux into the droplet. Consequently, the mechanism to control droplet temperature in the plasma MIG welding was clarified.Keywords
This publication has 27 references indexed in Scilit:
- Influence of welding current in plasma–MIG weld process on the bead weld geometry and wire fusion rateWelding International, 2011
- Theoretical model and experimental investigation of current density boundary condition for welding arc studyThe European Physical Journal Applied Physics, 2011
- Improvement of bead formation of plasma MIG welding in pure argon atmosphereQUARTERLY JOURNAL OF THE JAPAN WELDING SOCIETY, 2011
- The measurement of metal droplet temperature in GMA welding by infrared two-colour pyrometryWelding International, 2010
- Physical basis for the transition from globular to spray modes in gas metal arc weldingJournal of Physics D: Applied Physics, 2009
- Joule heating of solid wires in MAG weldingWelding International, 2005
- In-Situ Measurement of Metal Drop Temperature in GMA Short-Circuiting WeldingJournal of High Temperature Society, 2004
- Modelling and analysis of metal transfer in gas metal arc weldingJournal of Physics D: Applied Physics, 2003
- Metal transfer measurements in gas metal arc weldingJournal of Physics D: Applied Physics, 2001
- Physics of Welding. (III). Melting rate and temperature distribution of electrode wire.JOURNAL OF THE JAPAN WELDING SOCIETY, 1994