Pore Fluid Pressure Development in Compacting Fault Gouge in Theory, Experiments, and Nature
Open Access
- 18 January 2018
- journal article
- research article
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research: Solid Earth
- Vol. 123 (1) , 226-241
Abstract
The strength of fault zones is strongly dependent on pore fluid pressures within them. Moreover, transient changes in pore fluid pressure can lead to a variety of slip behavior from creep to unstable slip manifested as earthquakes or slow slip events. The frictional properties of low‐permeability fault gouge in nature and experiment can be affected by pore fluid pressure development through compaction within the gouge layer, even when the boundaries are drained. Here the conditions under which significant pore fluid pressures develop are analyzed analytically, numerically, and experimentally. Friction experiments on low‐permeability fault gouge at different sliding velocities show progressive weakening as slip rate is increased, indicating that faster experiments are incapable of draining the pore fluid pressure produced by compaction. Experiments are used to constrain the evolution of the permeability and pore volume needed for numerical modeling of pore fluid pressure build up. The numerical results are in good agreement with the experiments, indicating that the principal physical processes have been considered. The model is used to analyze the effect of pore fluid pressure transients on the determination of the frictional properties, illustrating that intrinsic velocity‐strengthening behavior can appear velocity weakening if pore fluid pressure is not given sufficient time to equilibrate. The results illustrate that care must be taken when measuring experimentally the frictional characteristics of low‐permeability fault gouge. The contribution of compaction‐induced pore fluid pressurization leading to weakening of natural faults is considered. Cyclic pressurization of pore fluid within fault gouge during successive earthquakes on larger faults may reset porosity and hence the capacity for compaction weakening.Keywords
Funding Information
- Natural Environment Research Council (NE/H012486/1, NE/J024449/1, NE/P002943/1)
- Leverhulme Trust
- Royal Society
This publication has 60 references indexed in Scilit:
- Towards quantifying the matrix permeability of fault damage zones in low porosity rocksEarth and Planetary Science Letters, 2012
- Physical properties of surface outcrop cataclastic fault rocks, Alpine Fault, New ZealandGeochemistry, Geophysics, Geosystems, 2012
- A review of recent developments concerning the structure, mechanics and fluid flow properties of fault zonesJournal of Structural Geology, 2010
- Internal structure and permeability of major strike-slip fault zones: the Median Tectonic Line in Mie Prefecture, Southwest JapanJournal of Structural Geology, 2003
- Comparisons of water and argon permeability in natural clay‐bearing fault gouge under high pressure at 20°CJournal of Geophysical Research, 2000
- The importance of overpressure timing and permeability evolution in fine-grained sediments undergoing shearJournal of Structural Geology, 1998
- Dilatancy, compaction, and slip instability of a fluid‐infiltrated faultJournal of Geophysical Research, 1995
- Dilatancy in hydraulically isolated faults and the suppression of instabilityGeophysical Research Letters, 1994
- Friction, overpressure and fault normal compressionGeophysical Research Letters, 1990
- Permeability and strength of San Andreas Fault gouge under high pressureGeophysical Research Letters, 1981