Ethernet-Based Car Control Network
- 1 January 2006
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1031-1034
Abstract
The use of networks for communication between electronic control units has increased in car industry over the last two decades. Several types of networks were developed for this purpose. In this study, Ethernet at gigabit speed is tested as a network for such system. The use of Ethernet helps integrating real-time control functions and non-real-time entertainment functions. Two main scenarios were simulated using OPNET. The fist one simulates pure control networks on board of a moving vehicle. The second scenario is the same as the first one with an added video load to simulate on-board entertainment. Both simulations were successful, as the end-to-end delays were below the maximum round-trip delays required by the systemKeywords
This publication has 12 references indexed in Scilit:
- Fault Tolerant Two-Level Pyramid Networked Control Systems2006
- Quantitative Evaluation of the Safety of X-by-Wire Architecture subject to EMI Perturbations2006
- Gigabit ethernet for redundant networked control systems2005
- Fault-tolerant networked control systems under varying load2005
- Trends in Automotive Communication SystemsProceedings of the IEEE, 2005
- Analysis of real-time control systems with time delays2002
- Design method for conceptual design of by-wire control: two case studies2002
- CAN for critical embedded automotive networksIEEE Micro, 2002
- By-wire cars turn the cornerIEEE Spectrum, 2001
- Performance evaluation of control networks: Ethernet, ControlNet, and DeviceNetIEEE Control Systems, 2001