Model predictive contouring control
Authors:
- 1 December 2010
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 01912216,p. 6137-6142
Abstract
Biaxial contouring systems involve competing control objectives of maximising accuracy while minimising traversal time. In this paper, a model predictive controller for contouring systems is proposed where the control inputs are determined by minimising a cost function which reflects the trade-off between these competing objectives, subject to state and actuator constraints. To facilitate real-time implementation, a linear time-varying approach is proposed, and stability is guaranteed by introducing an additional contraction constraint. Simulation results for an XY table system demonstrate the effectiveness of the proposed contouring control scheme.Keywords
This publication has 11 references indexed in Scilit:
- Idle speed control using linear time varying model predictive control and discrete time approximations2010
- Time-Optimal Path Tracking for Robots: A Convex Optimization ApproachIEEE Transactions on Automatic Control, 2009
- Performance limitations in reference tracking and path following for nonlinear systemsAutomatica, 2008
- Feed-rate optimization with jerk constraints for generating minimum-time trajectoriesInternational Journal of Machine Tools and Manufacture, 2007
- Quintic Spline Interpolation With Minimal Feed FluctuationJournal of Manufacturing Science and Engineering, 2005
- Contractive model predictive control for constrained nonlinear systemsIEEE Transactions on Automatic Control, 2000
- High speed servo control of multi-axis machine toolsInternational Journal of Machine Tools and Manufacture, 2000
- Optimal tracking of piezo-based nanopositionersNanotechnology, 1999
- Advanced Controllers for Feed DrivesCIRP Annals, 1992
- Time optimal contour tracking for machine tool controllersIEEE Control Systems, 1991