Influence of additives and plating parameters on morphology and mechanical properties of copper coatings obtained by pulse electrodeposition
Authors:
- N. ImazNIN. Imaz
- E. García-LecinaE. García-Lecina
- C. SuárezCSC. Suárez
- J. A. DíezJDJ. A. Díez
- J. RodríguezJRJ. Rodríguez
- J. MolinaJMJ. Molina
- V. García-NavasVGV. García-Navas
- 1 March 2009
- journal article
- Published by Taylor & Francis in Transactions of the IMF
- Vol. 87 (2) , 64-71
Abstract
No abstract availableKeywords
This publication has 17 references indexed in Scilit:
- Pulse plating effect on composition and corrosion properties of zinc alloy coatingsTransactions of the IMF, 2008
- Recent progress in pulse reversal plating of copper for electronics applicationsTransactions of the IMF, 2007
- Pulse plating of nickel: influence of electrochemical parameters and composition of electrolyteTransactions of the IMF, 2007
- The effect of additives on the pulsed electrodeposition of copperTransactions of the IMF, 2005
- Effect of plating mode, thiourea and chloride on the morphology of copper deposits produced in acidic sulphate solutionsElectrochimica Acta, 2005
- The annealing behavior of copper deposit electroplated in sulfuric acid bath with various concentrations of thioureaMaterials Science and Engineering: A, 2004
- Influence of additives on Cu electrodeposition mechanisms in acid solution: direct current study supported by non-electrochemical measurementsElectrochimica Acta, 2002
- Kinetic and morphological investigation of copper electrodeposition from sulfate electrolytes in the presence of an additive based on ethoxyacetic alcohol and triethyl-benzyl-ammonium chlorideMaterials Chemistry and Physics, 2001
- Electrodeposition for the synthesis of microsystemsJournal of Micromechanics and Microengineering, 2000
- The effect of pulsed reverse current on the polarization behaviour of acid copper plating solutions containing organic additivesJournal of Applied Electrochemistry, 1990