Proposal of a 2.4 GHz Rectifier With Temperature Range Trimming for Low-Power RF Energy Harvesting
Open Access
- 6 November 2024
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 12, 167278-167287
Abstract
This paper aims to study the effects of impedance mismatch in low-power Radio Frequency Energy Harvesting (RFEH) systems caused by the dependence of Schottky diode input impedance on temperature and propose solutions to mitigate them. Thus, the effects of temperature variation on impedance matching and Radio Frequency (RF) to Direct Current (DC) Power Conversion Efficiency (PCE) will be analyzed through the design, simulation and measurement of an RF rectifier to operate at low input power levels in the 2.4 GHz Industrial, Scientific and Medical (ISM) band in two specific temperature ranges, one around the 300 K (reference ambient temperature) and other around the 325 K (higher temperatures). In order to solve the problem of impedance mismatch due to the temperature dependence of the Schottky diode, the RF rectifier is designed with an Input Matching Network (IMN) with trimming of the stubs in parallel that can be enabled or disabled to set up the desired network and operate according to the temperature of the location. Considering an input power ( Pin ) of -20 dBm, the PCE obtained with the prototype configured for room temperature ( P 300 ) and for high temperature ( P 325 ) are of 14.73% and 10.53% at 283 K, 16.72% and 16.15% at 303 K, 12.74% and 15.39% at 323 K and 5.82% and 11.67% at 343 K, respectively. As possibly expected by this proposal, the results indicate a higher and more stabler PCE at high temperatures in the prototype configured for 325 K while at room temperature the PCE is higher and more stabler in the prototype configured for 300 K.Keywords
Funding Information
- São Paulo Research Foundation (FAPESP), Brazil (2022/10876-0, 2019/25866-7, 2022/08737-1)
- Coordination for the Improvement of Higher Education Personnel (001)
This publication has 33 references indexed in Scilit:
- A Versatile RF Energy Harvester for IoT Sensors in 5G Network With Extended Input Power RangeIEEE Access, 2024
- A Compact Broadband Stepped Bow-Tie Antenna for Ambient RF Energy HarvestingIEEE Access, 2023
- Temperature Analysis of Schottky Diodes Rectifiers for Low-Power RF Energy Harvesting ApplicationsIEEE Access, 2023
- High-Gain Circularly Polarized Antenna Array for Full Incident Angle Coverage in RF Energy HarvestingIEEE Access, 2023
- Harmonic Reaction Inductive Folded Dipole Antenna for Direct Connection With Rectifier DiodesIEEE Access, 2022
- A Review on Antenna Technologies for Ambient RF Energy Harvesting and Wireless Power Transfer: Designs, Challenges and ApplicationsIEEE Access, 2022
- A survey on low power RF rectifiers efficiency for low cost energy harvesting applicationsAEU - International Journal of Electronics and Communications, 2019
- Design and realization of an ultra-low power sensing RF energy harvesting module with its RF and DC sub-componentsInternational Journal of RF and Microwave Computer-Aided Engineering, 2019
- Temperature Effects on the Efficiency of Dickson Charge Pumps for Radio Frequency Energy HarvestingIEEE Access, 2018
- High temperature heat pumps: Market overview, state of the art, research status, refrigerants, and application potentialsEnergy, 2018