Design and performance analysis of hot side heat sink of thermoelectric cooler device based on simulation and experiment
Authors:
Open Access
- 10 October 2023
- journal article
- research article
- Published by Wiley in Energy Science & Engineering
- Vol. 11 (12) , 4463-4480
Abstract
As for improving the heat diversion capacity of the hot side heat sink of the thermoelectric cooler (TEC), thereby improving the operational performance of the TEC, this study designed a type of double‐embedded flat heat pipe (EFHP) finned heat sink and compared with a standard aluminum (Al) heat sink. In experimental studies, TEC under two heat sinks were placed under different operating currents for heat transfer analysis and performance comparison. The experimental results demonstrated that the EFHP heat sink had better heat diversion ability, effectively improving the operational performance of TEC. When the TEC was input with a current of 6A, the thermal resistance of the double EFHP finned heat sink decreased by 19% compared to the Al heat sink; cooling capacity and coefficient of performance increased by 8.3% and 9.46%, respectively. Further, TEC's cold and hot surface temperatures decreased by 10.83% and 10.2%, respectively, and the heat uniformity of the heat sink improved. In addition, the CFD software Icepak was used to analyze the effects of double flat heat pipe spacing and length on the heat sink and TEC and the performance of two heat sinks and TEC under different heat dissipation conditions and obtained good agreement. This study can provide further guidance and assistance in designing the TEC cooling system.Keywords
This publication has 41 references indexed in Scilit:
- A novel heat dissipation fin design applicable for natural convection augmentationInternational Communications in Heat and Mass Transfer, 2014
- Analysis on optimal heat exchanger size of thermoelectric cooler for electronic cooling applicationsEnergy Conversion and Management, 2013
- Geometry optimization of thermoelectric coolers using simplified conjugate-gradient methodEnergy, 2013
- Design optimization of thermoelectric cooling systems for applications in electronic devicesInternational Journal of Refrigeration, 2012
- A general approach in evaluating and optimizing thermoelectric coolersInternational Journal of Refrigeration, 2010
- Analysis of thermoelectric cooler performance for high power electronic packagesApplied Thermal Engineering, 2010
- Development of a thermoelectric refrigerator with two-phase thermosyphons and capillary liftApplied Thermal Engineering, 2009
- Analysis of optimum configuration of two-stage thermoelectric modulesCryogenics, 2007
- Measurements and simulations of transient characteristics of heat pipesMicroelectronics Reliability, 2006
- Increase of COP in the thermoelectric refrigeration by the optimization of heat dissipationApplied Thermal Engineering, 2003