Mechanism and kinetics of curing of diglycidyl ether of bisphenol a (DGEBA) resin by chitosan
Authors:
- 12 October 2016
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 57 (8) , 865-874
Abstract
Crosslinking behavior of Diglycidyl Ether of Bisphenol A (DGEBA) resins cured by chitosan was isothermally studied by Fourier Transform Infrared (FTIR) Spectroscopy for various molar ratios of chitosan at different temperatures. Results indicated that oxirane undergoes nucleophilic attack by the primary amine groups in chitosan to form crosslinked structure. Epoxy fractional conversion (α) was calculated by following the change in area of oxirane peak at 914 cm−1. Value of α and reaction rate (dα/dt) increased with increase in curing temperature and chitosan concentration. The maximum epoxy fractional conversion of 70% was obtained for 1:4 molar ratio (Epoxy:Chitosan) at 200°C. A four parameter kinetic model with two rate constants was employed to simulate the experimental data. Overall reaction order and activation energy for all compositions were in the range of 2.5–3 and 25–50 kJ mol−1, respectively. Results indicated that cure reaction is autocatalytic and does not follow simple nth order cure kinetics. Thermogravimetric analysis (TGA) performed on chitosan cured DGEBA films and compared against neat epoxy and neat chitosan films. Results showed that the degradation of chitosan crosslinked epoxy network occurred in the temperature range of 450–550°C. POLYM. ENG. SCI., 57:865–874, 2017. © 2016 Society of Plastics EngineersKeywords
This publication has 22 references indexed in Scilit:
- Graphene oxide cross-linked chitosan nanocomposite membraneApplied Surface Science, 2013
- The influence of formulation and processing parameters on the thermal properties of a chitosan–epoxy prepolymer systemPolymer International, 2013
- Functional properties of chitosan-based filmsCarbohydrate Polymers, 2013
- A novel and efficient epoxy/chitosan cement slurry for use in severe acidic environments of oil wells—Structural characterization and kinetic modelingJournal of Hazardous Materials, 2012
- Chitin and chitosan polymers: Chemistry, solubility and fiber formationProgress in Polymer Science, 2009
- Film‐forming process and biocide assessment of high‐molecular‐weight chitosan as determined by combined ATR‐FTIR spectroscopy and antimicrobial assaysBiopolymers, 2006
- Novel curing agent for lead‐free electronics: Amino acidJournal of Polymer Science Part A: Polymer Chemistry, 2005
- A review of chitin and chitosan applicationsReactive and Functional Polymers, 2000
- Thermoset characterization for moldability analysisPolymer Engineering & Science, 1974
- Kinetics and thermal characterization of thermoset curePolymer Engineering & Science, 1973