On the Flow Structure and Dynamics of Methane and Syngas Lean Flames in a Model Gas-Turbine Combustor
Open Access
Abstract
The present paper compares the flow structure and flame dynamics during combustion of methane and syngas in a model gas-turbine swirl burner. The burner is based on a design by Turbomeca. The fuel is supplied through injection holes between the swirler blades to provide well-premixed combustion, or fed as a central jet from the swirler’s centerbody to increase flame stability via a pilot flame. The measurements of flow structure and flame front are performed by using the stereo particle image velocimetry and OH planar laser-induced fluorescence methods. The measurements are performed for the atmospheric pressure without preheating and for 2 atm with the air preheated up to 500 K. The flow Reynolds numbers for the non-reacting flows at these two conditions are 1.5 × 103 and 1.0 × 103, respectively. The flame dynamics are analyzed based on a high-speed OH* chemiluminescence imaging. It is found that the flame dynamics at elevated conditions are related with frequent events of flame lift-off and global extinction, followed by re-ignition. The analysis of flow structure via the proper orthogonal decomposition reveals the presence of two different types of coherent flow fluctuations, namely, longitudinal and transverse instability modes. The same procedure is applied to the chemiluminescence images for visualization of bulk movement of the flame front and similar spatial structures are observed. Thus, the longitudinal and transverse instability modes are found in all cases, but for the syngas at the elevated pressure and temperature the longitudinal mode is related to strong thermoacoustic fluctuations. Therefore, the present study demonstrates that a lean syngas flame can become unstable at elevated pressure and temperature conditions due to a greater flame propagation speed, which results in periodic events of flame flash-back, extinction and re-ignition. The reported data is also useful for the validation of numerical simulation codes for syngas flames.Keywords
Funding Information
- Ministry of Education and Science of Russia (075-15-2020-806)
- National Key R&D Program of China (2017YFE0123100)
This publication has 79 references indexed in Scilit:
- Characterization of the Acoustic Interactions in a Two-Stage Multi-Injection Combustor Fed With Liquid FuelJournal of Engineering for Gas Turbines and Power, 2012
- Turbulent flame speed for syngas at gas turbine relevant conditionsProceedings of the Combustion Institute, 2011
- Gas turbine combustion performance test of hydrogen and carbon monoxide synthetic gasFuel, 2010
- On the Adequacy of Chemiluminescence as a Measure for Heat Release in Turbulent Flames With Mixture GradientsJournal of Engineering for Gas Turbines and Power, 2010
- Laboratory investigations of a low-swirl injector with H2 and CH4 at gas turbine conditionsProceedings of the Combustion Institute, 2009
- Combustion Instabilities and Control of a Multiswirl Atmospheric CombustorJournal of Engineering for Gas Turbines and Power, 2006
- Experimental Study on Stabilization of Lifted Swirl Flames in a Model GT CombustorFlow, Turbulence and Combustion, 2005
- Establishment of a Confined Swirling Natural Gas/Air Flame as a Standard Flame: Temperature and Species Distributions from Laser Raman MeasurementsCombustion Science and Technology, 2002
- Fluorescence imaging of OH and NO in a model supersonic combustorAIAA Journal, 1993
- Numerical and Experimental Studies of Hydroxyl Radical Chemiluminescence in Methane-Air FlamesCombustion Science and Technology, 1992