A Gripper Actuated by a Pair of Differential SMA Springs
Authors:
- 1 May 2007
- journal article
- research article
- Published by SAGE Publications in Journal of Intelligent Material Systems and Structures
- Vol. 18 (5) , 459-466
Abstract
This article presents a gripper actuated by a pair of differential shape memory alloy (SMA) springs. The mechanical structure of the gripper includes a pair of fingers, a coupler, a tension rod, a slider, and a frame. An experimental setup of the SMA gripper is established. The SMA actuator is heated by the electric current and cooled by fans. Thermal resistance sensors are used to measure the temperature of the SMA springs and a slide rheostat is used to sense the output displacement of the actuator. In order to evaluate the potential of the SMA actuator for application to the proposed gripper, three types of tests are performed as follows: influence of the cooling methods, heating current, and action frequency on the characteristics of the SMA actuator and the gripper. The experimental results show that the output displacement amplitude can increase by increasing the heating current and decreasing the action frequency. A good cooling method can increase the cyclic output displacement amplitude and the bandwidth of the SMA actuator. A proportional-integral (PI) controller is presented to control the output position of the gripper, and a two-phase control method is developed to reduce the overshooting of the system. Position control experiments for the SMA gripper are performed, and the experimental results demonstrate that a good position control performance of the gripper is obtained by using the proposed controller.Keywords
This publication has 9 references indexed in Scilit:
- Three-finger SMA robot hand and its practical analysisRobotica, 2002
- Comparative Evaluation of Shape Memory Alloy Constitutive Models with Experimental DataJournal of Intelligent Material Systems and Structures, 2001
- In-flight tracking of helicopter rotor blades using shape memory alloy actuatorsSmart Materials and Structures, 2001
- Evaluation of the characteristics of a shape memory alloy spring actuatorSmart Materials and Structures, 2000
- Time Response of Shape Memory Alloy ActuatorsJournal of Intelligent Material Systems and Structures, 2000
- Characterization of the pseudoelastic damping behavior of shape memory alloy wires using complex modulusSmart Materials and Structures, 1999
- Design aspects of shape memory actuatorsMechatronics, 1998
- Experimental Investigation of the Pseudoelastic Hysteresis Damping Characteristics of Shape Memory Alloy WiresJournal of Intelligent Material Systems and Structures, 1998
- A practical microgripper by fine alignment, eutectic bonding and SMA actuationSensors and Actuators A: Physical, 1996