Maximization of the effective impulse delivered by a high-frequency/low-frequency planetary drill tool
Authors:
- 10 November 2011
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
- Vol. 58 (11) , 2387-2396
Abstract
Ultrasonic tools are used for a variety of cutting applications in surgery and the food industry, but when they are applied to harder materials, such as rock, their cutting performance declines because of the low effective impulse delivered by each vibration cycle. To overcome this problem, a technique known as high-frequency/low-frequency (or alternatively, ultrasonic/sonic) drilling is employed. In this approach, an ultrasonic step-horn is used to deliver an impulse to a free mass which subsequently moves toward a drilling bit, delivering the impulse on contact. The free mass then rebounds to complete the cycle. The horn has time between impacts to build significant vibration amplitude and thus delivers a much larger impulse to the free mass than could be delivered if it were applied directly to the target. To maximize the impulse delivered to the target by the cutting bit, both the momentum transfer from the ultrasonic horn to the free mass and the dynamics of the horn/free mass/cutting bit stack must be optimized. This paper uses finite element techniques to optimize the ultrasonic horns and numerical propagation of the stack dynamics to maximize the delivered effective impulse, validated in both cases by extensive experimental analysis.Keywords
This publication has 11 references indexed in Scilit:
- Optimization of the Horn, Free-Mass, and Support Architecture of a Solid Ultrasonic Rock Coring System2010
- Magna Parva and ESA's Ultrasonic Drill Tool for Planetary Surface Exploration2010
- The Apollo Medical Operations Project: Recommendations to improve crew health and performance for future exploration missions and lunar surface operationsActa Astronautica, 2008
- Modelling approaches for an ultrasonic percussion drillJournal of Sound and Vibration, 2007
- Subsurface sampler and sensors platform using the ultrasonic/sonic driller/corer (USDC)2007
- Methods for reducing cutting temperature in ultrasonic cutting of boneUltrasonics, 2006
- The ultrasonic/sonic driller/corer (USDC) as a subsurface drill, sampler, and lab-on-a-drill for planetary exploration applications2005
- Novel horn designs for power ultrasonics2005
- Modeling and computer simulation of ultrasonic/sonic driller/corer (USDC)IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2003
- Modeling of horns for sonic/ultrasonic applications1999