Personal Exposures to Asbestos Fibers During Brake Maintenance of Passenger Vehicles
Open Access
- 27 August 2012
- journal article
- research article
- Published by Oxford University Press (OUP) in Annals of Occupational Hygiene
- Vol. 56 (9) , 985-999
Abstract
Brake linings and brake pads are among the asbestos-containing products that are readily available in Colombia. When sold separated from their support, brake linings require extensive manipulation involving several steps that include drilling, countersinking, riveting, bonding, cutting, beveling, and grinding. Without this manipulation, brake linings cannot be installed in a vehicle. The manipulation process may release asbestos fibers, which may expose brake mechanics to the fibers. Three brake repair shops located in Bogotá (Colombia) were sampled for 3 or 4 consecutive days using US National Institute for Occupational Safety and Health (NIOSH) methods 7400 and 7402. Standard procedures for quality control were followed during the sampling process, and asbestos samples were analyzed by an American Industrial Hygiene Association accredited laboratory. Personal samples were collected to assess full-shift and short-term exposures. Area samples were also collected close to the brake-lining manipulation equipment and within office facilities. Activities were documented during the sampling process. Using Phase Contrast Microscopy Equivalent counts to estimate air asbestos concentrations, all personal samples [i.e. 8-h time-weighted averages (TWAs) and 30-min personal samples] were in compliance with the US Occupational Safety and Health Administration standards. Personal asbestos concentrations based on transmission electron microscopy counts were extremely high, ranging from 0.006 to 3.493 f cm −3 for 8-h TWA and from 0.015 to 8.835 f cm−3 for 30-min samples. All asbestos fibers detected were chrysotile. Cleaning facilities and grinding linings resulted in the highest asbestos exposures based on transmission electron microscopy counts. There were also some samples that did not comply with the NIOSH’s recommended exposure limits. The results indicate that the brake mechanics sampled are exposed to extremely high asbestos concentrations (i.e. based on transmission electron microscopy counts), suggesting that this occupational group could be at excess risk of asbestos-related diseases.Keywords
This publication has 12 references indexed in Scilit:
- The Case for a Global Ban on AsbestosEnvironmental Health Perspectives, 2010
- Airborne asbestos exposure during light aircraft brake replacementRegulatory Toxicology and Pharmacology, 2009
- A review of carcinogenicity studies of asbestos and non-asbestos tremolite and other amphibolesRegulatory Toxicology and Pharmacology, 2008
- An evaluation of short-term exposures of brake mechanics to asbestos during automotive and truck brake cleaning and machining activitiesJournal of Exposure Science & Environmental Epidemiology, 2008
- Naturally occurring asbestos—A recurring public policy challengeJournal of Hazardous Materials, 2008
- Assessment of airborne asbestos exposure during the servicing and handling of automobile asbestos-containing gasketsRegulatory Toxicology and Pharmacology, 2006
- Environmental and Occupational Health Hazards Associated with the Presence of Asbestos in Brake Linings and Pads (1900 to Present): A "State-of-the-Art" ReviewJournal of Toxicology and Environmental Health, Part B, 2004
- An Evaluation of the Historical Exposures of Mechanics to Asbestos in Brake DustApplied Occupational and Environmental Hygiene, 2003
- Airborne asbestos concentration from brake changing does not exceed permissible exposure limitRegulatory Toxicology and Pharmacology, 2003
- Exposure to Asbestos during Brake MaintenanceAnnals of Occupational Hygiene, 1970