Dynamic Simulator for a PEM Fuel Cell System With a PWM DC/DC Converter
Authors:
- Soo-Hyun BaekSBSoo-Hyun Baek
- 30 April 2008
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Energy Conversion
- Vol. 23 (2) , 669-680
Abstract
Polymer electrolyte membrane (PEM) fuel cells typically have low voltage, high current, terminal characteristics that cannot accommodate common electric loads like electric motors or power utility grids. Thus, a dc/dc converter is required to boost the output voltage of these power systems. Furthermore, the terminal characteristics are dependent on loads and operating conditions of the fuel cell system. The continuously changing power demand of an electric load requires dynamically replenishing the air and fuel, by properly maintaining humidity in the cell and efficiently rejecting the heat produced. These factors present important challenges for the design of reliable and durable power systems. We present new dynamic models for a fuel cell system and a pulsewidth modulation dc/dc converter with associated controls and integration. The model for the system consists of three subsystems that include an PEM fuel cell stack, an air supply, and a thermal system. Four different controllers were designed to control the air, the coolant, and the output voltage of the converter, and to optimize the power flow between the fuel cell and the output capacitor. The integrated model with its controls was tested using a real-time simulator that reduced computational time and facilitated the analysis of the interactions between loads and the fuel cell components and also allowed the optimization of a power control strategy. The responses of a static and dynamic load show that the power controls proposed can coordinate two energy sources, resulting in improved dynamics and efficiency.Keywords
This publication has 15 references indexed in Scilit:
- Modeling and simulation of a PEM fuel cell stack considering temperature effectsJournal of Power Sources, 2006
- Modeling and Simulation of a Modern PEM Fuel Cell System2006
- Development of an equivalent circuit model of a fuel cell to evaluate the effects of inverter ripple current2004
- Analytical and experimental investigations of a proton exchange membrane fuel cellInternational Journal of Hydrogen Energy, 2004
- Modelling static and dynamic behaviour of proton exchange membrane fuel cells on the basis of electro-chemical descriptionJournal of Power Sources, 2003
- Modeling fuel cell stack systemsJournal of Power Sources, 1998
- Dynamic modelling and simulation of a polymer membrane fuel cell including mass transport limitationInternational Journal of Hydrogen Energy, 1998
- Performance Modeling of the Ballard Mark IV Solid Polymer Electrolyte Fuel Cell: II . Empirical Model DevelopmentJournal of the Electrochemical Society, 1995
- A Water and Heat Management Model for Proton‐Exchange‐Membrane Fuel CellsJournal of the Electrochemical Society, 1993
- Polymer Electrolyte Fuel Cell ModelJournal of the Electrochemical Society, 1991