Microstructure and properties of open‐cell Ni–Sn–P alloy foams prepared by electroless plating
Authors:
- 12 December 2019
- journal article
- research article
- Published by Wiley in Materials and Corrosion
- Vol. 71 (6) , 924-930
Abstract
In this study, open‐cell Ni–Sn–P alloy foams were prepared by electroless plating. The influence of tin content on the surface morphology and properties of Ni–Sn–P alloy foams were investigated. The surface structure of Ni–Sn–P alloy foams became more uniform and compact with the increase of Sn content. The X‐ray diffraction result showed that Ni–Sn–P alloy foams gradually transformed from an amorphous structure into crystallization with the increase of heat‐treatment temperature. The introduction of Sn significantly enhanced the corrosion resistance of Ni–P coatings in 3.5 wt% NaCl solution, the corrosion current density decreased from 5.022 to 0.805 μA/cm2 and the corrosion potential shifted positively from −0.423 to −0.294 V after adding 5.96 wt% Sn to Ni–P coatings. However, the corrosion resistance of Ni–Sn–P foams was deteriorated after heat treatment. Adding Sn to the Ni–P system slightly weakened the compressive strength of Ni–P binary foams. Nevertheless, significant improvement in the antioxidant performance of Ni–Sn–P alloy foams was indicated by the reduction of the mass change rate in that the mass change rate of Ni–P foams obviously reduced from 5.15% to 0.25% after adding 5.96 wt% Sn.Keywords
Funding Information
- Technology Development Plan of Hunan Province of China (2018GK4036)
This publication has 28 references indexed in Scilit:
- Synthesis and properties of open-cell Ni–Cr–Fe–Al alloy foams by pack co-deposition processJournal of Materials Processing Technology, 2012
- The effect of TiO2 nanoparticle codeposition on microstructure and corrosion resistance of electroless Ni-P coatingMaterials and Corrosion, 2011
- Preparation and Properties of Electroless Deposited Ni-Sn-P Ternary Alloy CoatingsAdvanced Materials Research, 2011
- Electrochemical behavior of nanocrystalline Ni–P alloys containing tin and tungstenProtection of Metals and Physical Chemistry of Surfaces, 2010
- Effect of Tin Addition on the Properties of Electroless Ni-P-Sn Ternary DepositsMATERIALS TRANSACTIONS, 2010
- Mechanical properties of reticulated aluminum foams with electrodeposited Ni–W coatingsScripta Materialia, 2008
- Studies on the Dynamic Compressive Properties of Open-Celled Aluminum Alloy FoamsKey Engineering Materials, 2006
- Crystallization temperature of amorphous electroless nickel–phosphorus alloysMaterials Letters, 2005
- Electroless Deposition of Ni–Sn–P and Ni–Sn–Cu–P CoatingsJournal of the Electrochemical Society, 2005
- Manufacture, characterisation and application of cellular metals and metal foamsProgress in Materials Science, 2001