Tribological mechanism of hydrogenated amorphous carbon film against pairs: A physical description
Authors:
- 1 August 2011
- journal article
- conference paper
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 110 (3) , 033521
Abstract
The objective of the present study was to investigate the friction and wear mechanisms of hydrogenated amorphous carbon (a-C:H) films sliding against different counterparts. Friction tests were performed by a reciprocating ball-on-disk tribometer with an applied load of 5 N, amplitude of 5 mm, and frequency of 5 Hz, in ambient air at room temperature. The coefficient of friction (COF) was consistent with the varied tendency of the contact area of the counterparts on films and also coincided with the varied tendency of the coverage of transfer film on friction ball surface. It was important to point out that the coverage of the transfer film on the counterpart surface was inversely proportional to the contact area. Furthermore, COF of a-C:H films against different pairs was independent with the film graphitization level. Additionally, wear rate of a-C:H films against different friction pairs was discussed in details. Some indexes including hardness ratio of pair and film, elastic energy density of the friction pair, and effective plastic index were employed to predicting the wear behavior of the a-C:H films sliding against different counterparts. Compared with other indexes, the effective plastic index showed best performance. Description of physical meanings and some formula derivation of the effective plastic index of film with applied load were also performed in this work. The results increased our understanding of the physical mechanism of a-C:H films sliding against pairs, which were able to guide the application of a-C:H films in the future industrial fields.Keywords
This publication has 13 references indexed in Scilit:
- Influence of hardness and roughness on the tribological performance of TiC/a-C nanocomposite coatingsSurface and Coatings Technology, 2010
- The Dependence of Energy Dissipation on the Elastic Energy Density of Friction Pairs in Hard Coating FilmsTribology Letters, 2010
- Effect of oil additives on the durability of hydrogenated DLC coating under boundary lubrication conditionsWear, 2009
- The preparation and mechanical properties of Al-containing a-C : H thin filmsJournal of Physics D: Applied Physics, 2007
- Substrate bias effect on structure of tetrahedral amorphous carbon films by Raman spectroscopyDiamond and Related Materials, 2007
- Thermal conductivity of diamond-like carbon filmsApplied Physics Letters, 2006
- Dry sliding behaviour of non-hydrogenated DLC coatings against Al, Cu and Ti in ambient air and argonDiamond and Related Materials, 2006
- Friction behaviors of hydrogenated diamond-like carbon film in different environment sliding against steel ballApplied Surface Science, 2005
- On the significance of the H/E ratio in wear control: a nanocomposite coating approach to optimised tribological behaviourWear, 2000
- Interpretation of Raman spectra of disordered and amorphous carbonPhysical Review B, 2000